N8148K Gulfstream-Schweizer G-164B accident

NTSB LAX08LA083 · 2008-03-22 · Genesee, ID

Docket — crew, injuries and powerplant

Summary

"THIS CASE WAS MODIFIED MARCH 25, 2009." The airplane was departing on an aerial application sortie when the lower portion of the rudder separated and yaw control was lost. The pilot flew the airplane for approximately 1/2 hour to learn its flight characteristics at low airspeeds and low power settings. During the landing, the airplane turned sideways, nosed over, and came to rest inverted. Examination of the rudder revealed that the lower rudder attachment point had failed. The separation surfaces displayed evidence of severe corrosion. The airplane had an annual inspection on March 17, 2008, and had flown 1/2 hour since the inspection. The area where the corrosion was found and the failure occurred did not require inspection.

Full narrative

"THIS CASE WAS MODIFIED MARCH 25, 2009."

On March 22, 2008, approximately 0930 Pacific daylight time, a Gulfstream-Schweizer G-164B, N8148K, was substantially damaged during landing following the partial separation of its rudder, while in-flight, near Genesee, Idaho. The commercial pilot, the sole occupant in the airplane, sustained a minor injury. Heimgartner Aviation LLC, was operating the airplane under 14 CFR Part 137. The airplane was on an aerial application sortie when the rudder failed; it had departed a private airstrip at approximately 0900. Visual meteorological conditions prevailed for the local flight; a flight plan had not been filed.

The pilot said that a few minutes after takeoff, he lost rudder control. He flew the airplane for approximately 1/2 hour to learn its flight characteristics at low airspeed and low power setting. During the landing, the airplane turned sideways, nosed over, and came to rest inverted.

Examination of the airplane by Federal Aviation Administration (FAA) inspectors revealed that the lower rudder attachment point had failed and the separation surfaces displayed evidence of severe corrosion. The airplane had an annual inspection on March 17, 2008, and the airplane had flown 1/2 hour since the inspection. On December 19, 2008, the FAA issued Airworthiness Directive (AD) 2008-22-21, which expanded the applicability of a previous AD 78-08-09 to include all G-164 series airplanes. The previous AD did not include the accident airplane. The expanded AD requires repetitive inspections of the rudder main tubular spar for corrosion and correction if detected. Prior to this AD, the area where the corrosion was found and failure occurred did not require inspection.

Probable cause

The in-flight failure of the rudder attachment point due to severe corrosion, which made directional control of the airplane not possible during landing. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
70
Wind speed (kt)
7
Temperature (F)
39
Nearest airport
Heimgartner Airstrip
Distance from field
0.0
Airport elevation
2460

Aircraft

RegistrationMakeModelDamageFAR part
N8148K Gulfstream-Schweizer G-164B SUBS 137

Sequence of events

#OccurrencePhase
1 Initial climb Aircraft structural failure defining Takeoff
2 Landing-flare/touchdown Loss of control on ground Cruise
3 Landing-flare/touchdown Nose over/nose down Cruise

Findings

Finding
Aircraft-Aircraft systems-Flight control system-Rudder control system-Fatigue/wear/corrosion cause
Personnel issues-Task performance-Inspection-Scheduled/routine inspection-Maintenance personnel - F cause
Aircraft-Aircraft systems-Flight control system-Rudder control system-Failure cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Directional control-Attain/maintain not possible cause