N4010Q accident

NTSB LAX08LA086 · 2008-03-26 · Henderson, NV · near HND

Docket — crew, injuries and powerplant

Summary

The pilot reported that following a normal takeoff he retracted the landing gear and noticed excessive drag. The pilot performed a low pass over the runway and ground-based witnesses observed that the right main landing gear appeared "twisted." The pilot then proceeded to his intended destination airport with emergency services and executed a gear up landing in gravel just short of the runway. Postaccident examination revealed that the left-hand main landing gear torque link upper attach fitting had fractured and the fracture surfaces exhibited an angular jagged matte, consistent with overload. The reason for the failure of the left main landing gear torque link assembly was undetermined.

Full narrative

On March 26, 2008, at 1550 Pacific daylight time, a Cessna 402, N4010Q, was substantially damaged during a gear up landing at the Henderson Executive Airport (HND), Henderson, Nevada. The airplane was registered to SkyVentures LLC, and operated by King Airelines, Inc., under the provisions of 14 Code of Federal Regulations Part 135. Visual meteorological conditions prevailed and a company visual flight rules flight plan was filed for the on-demand air taxi flight. The cross-country flight originated from the Canyon West Airport (1G4), Peach Springs, Arizona, at 1500.

In a written statement, the pilot reported that following a normal takeoff from 1G4, he observed normal gear up and locked indications via the landing gear position lights. Immediately following the gear retraction, he noticed excessive drag and decided to perform a low approach to the runway so personnel on the ground could assess the situation. Ground based witnesses observed that the right landing gear appeared "twisted."

The pilot continued the flight to HND where emergency services were available. He executed two low approaches to have ground crew reassess the condition of the landing gear. The pilot then executed an intentional gear up landing in a gravel area just short of the runway in an attempt to minimize damage to the airplane.

Examination of the airplane by a Federal Aviation Administration (FAA) inspector revealed that the left-hand main landing gear torque link upper attach fitting was separated and the fracture surfaces exhibited an angular jagged matte appearance. The reason for the failure of the left main landing gear torque link assembly was undetermined.

Probable cause

The failure of the left main landing gear torque link assembly for undetermined reasons. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
20
Wind direction
210
Wind speed (kt)
13
Temperature (F)
75
Nearest airport
Henderson Executive Airport
Distance from field
0.0
Airport elevation
2492

Aircraft

RegistrationMakeModelDamageFAR part
N4010Q — — SUBS 135

Sequence of events

#OccurrencePhase
1 Initial climb Sys/Comp malf/fail (non-power) defining Takeoff
2 Landing Landing gear not configured Cruise

Findings

Finding
Not determined-Not determined-(general)-(general)-Unknown/Not determined cause
Aircraft-Aircraft systems-Landing gear system-Main landing gear-Failure factor