N9357F Hughes 269B accident
NTSB CHI08CA164 · 2008-06-15 · Cook, MN
Docket — crew, injuries and powerplant
Summary
The pilot stated that he was cruising east in a helicopter. He made a 180 degree turn to the right, flew west for about 40 seconds, and made a 180 degree turn to right. The pilot reported that he rolled out of the turn, but the helicopter continued to turn right. He said that he landed flat, and the spinning helicopter rolled onto its right side. The helicopter was examined after the accident, and no preimpact anomalies were detected. The pilot's safety recommendation was, "Watch your airspeed when turning right so that your tail can still maintain control."
Full narrative
The pilot stated that he was cruising east bound in a helicopter. He made a 180 degree turn to the right, flew west for about 40 seconds, and made a 180 degree turn to right. The pilot reported that he rolled out of the turn and that the helicopter continued to turn right. He said that he landed "flat" and "with the spin the helicopter rolled onto its right side." The airplane was examined after the accident and no pre-impact anomalies were detected. The pilot's safety recommendation was, "Watch your airspeed when turning right so that your tail can still maintain control."
Probable cause
The pilot not maintaining tail rotor effectiveness while turning in cruise. The National Transportation Safety Board determined the probable cause of this accident.
Circumstances
- Event type
- Accident
- Highest injury
- Minor
- Weather conditions
- Visual Meteorological Cond
- Light condition
- Day
- Ceiling (ft)
- 0
- Wind direction
- 0
- Distance from field
- 0.0
Aircraft
| Registration | Make | Model | Damage | FAR part |
|---|---|---|---|---|
| N9357F | Hughes | 269B | SUBS | 091 |
Sequence of events
| # | Occurrence | Phase |
|---|---|---|
| 1 | Enroute-cruise Loss of control in flight defining | Climb |
| 2 | Landing Roll over | Cruise |
Findings
| Finding | |
|---|---|
| Aircraft-Aircraft propeller/rotor-Rotorcraft flight control-Tail rotor control system-Incorrect use/operation | cause |