N54LC Schweizer 269C accident

NTSB LAX08CA178 · 2008-06-13 · Cedar Valley, UT · near UT99

Docket — crew, injuries and powerplant

Summary

The pilot reported that the purpose of the flight was to demonstrate the helicopter's performance at an air show. He traveled from overseas by scheduled airline, arriving 2 days before the air show. The day before the air show he flew the helicopter for 50 minutes of demonstration practice at a similar density altitude to that anticipated for the following day's performance. The accident flight began about 1315, and the first two maneuvers were completed without incident. The third maneuver was "a standard 180-degree 'wing-over' commenced from a standard 300 feet." According to the pilot, the helicopter "failed to fully recover from the descent phase of the maneuver and struck the surface at approximately 40-50 knots." The helicopter rolled onto its left side. The pilot reported that the density altitude at the time of the accident was 8,500 feet. He stated that the accident could have been prevented "possibly by greater awareness and practice at the local density altitude conditions."

Full narrative

The pilot reported that the purpose of the flight was to demonstrate the helicopter's performance at an air show. He traveled from overseas by scheduled airline, arriving 2 days before the air show. The day before the air show he flew the helicopter for 50 minutes of demonstration practice at a similar density altitude to that anticipated for the following day's performance. The accident flight began about 1315, and the first two maneuvers were completed without incident. The third maneuver was "a standard 180-degree 'wing-over' commenced from a standard 300 feet." According to the pilot, the helicopter "failed to fully recover from the descent phase of the maneuver and struck the surface at approximately 40-50 knots." The helicopter rolled onto its left side. The pilot reported that the density altitude at the time of the accident was 8,500 feet. He stated that the accident could have been prevented "possibly by greater awareness and practice at the local density altitude conditions."

Probable cause

The pilot's failure to maintain terrain clearance while maneuvering. A contributing factor was the high density altitude. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
15
Wind direction
0
Temperature (F)
73
Nearest airport
West Desert Airpark
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N54LC Schweizer 269C SUBS 091

Sequence of events

#OccurrencePhase
2 Maneuvering-low-alt flying Low altitude operation/event defining Climb

Findings

Finding
Environmental issues-Conditions/weather/phenomena-Temp/humidity/pressure-High density altitude-Contributed to outcome cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Altitude-Not attained/maintained cause