N4029G Bell 47G-3B-2 accident

NTSB CHI08CA210 · 2008-07-24 · Lafetyette, IN

Docket — crew, injuries and powerplant

Summary

The helicopter began losing engine power during an aerial application run while maneuvering. The pilot attempted a landing in the field and the helicopter impacted terrain about 80 yards from an access road at the north edge of the field. The helicopter sustained substantial damage. The pilot was uninjured. Examination of the helicopter revealed that the carburetor heat control spring that keeps the carburetor closed was broken and its support rod had worn into the housing. The heat valve could only be opened about 1/3 and while corresponding cockpit control remained in the closed position. The fracture surface of the spring was consistent with fatigue. The spring had accumulated a total time in service of 832 hours. The pilot was a certificated aircraft mechanic who also performed maintenance on the helicopter. A National Transportation Safety Board Pilot/Operator Aircraft Accident/Incident Report was not received from the pilot.

Full narrative

The helicopter began losing engine power during an aerial application while maneuvering. The pilot attempted a landing in the field where the helicopter impacted terrain about 80 yards from an access road at the north edge of the field. The helicopter sustained substantial damage. The pilot was uninjured. Examination of the helicopter revealed that the carburetor heat control spring that keeps the carburetor closed was broken and its support rod had worn into the housing. The heat valve could only be opened about 1/3 and while corresponding cockpit control remained in the closed position. The fracture surface of the spring was consistent with fatigue. The spring accumulated a total time in service of 832 hours. The pilot was a certificated aircraft mechanic who also performed maintenance on the helicopter. A National Transportation Safety Board Pilot/Operator Aircraft Accident/Incident Report was not received from the pilot.

Probable cause

The loss of engine power during an aerial application flight due to a fatigue fracture of the carburetor heat control valve spring and the inadequate maintenance inspection by the pilot/mechanic. An additional cause was the low altitude of the operation. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Ceiling (ft)
0
Wind direction
0
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N4029G Bell 47G-3B-2 SUBS 137

Sequence of events

#OccurrencePhase
1 Maneuvering-low-alt flying Loss of engine power (total) defining Climb
2 Emergency descent Off-field or emergency landing Descent
3 Landing Collision with terr/obj (non-CFIT) Cruise

Findings

Finding
Aircraft-Aircraft power plant-Engine fuel and control-Fuel control/carburetor-Fatigue/wear/corrosion cause
Personnel issues-Task performance-Inspection-Scheduled/routine inspection-Pilot cause