N7195Y accident

NTSB NYC08CA315 · 2008-09-18 · Jefferson, GA · near 19A

Docket — crew, injuries and powerplant

Summary

Upon arrival at his destination airport, the pilot of a PA-30 attempted to extend his landing gear in preparation for landing. He discovered that one of the landing gear system circuit breakers had tripped. He attempted to reset the circuit breaker, but it would not reset. He then attempted to reset it a second time and was successful; he observed that the "green" landing gear down light was illuminated. During the landing roll, however, the landing gear collapsed and the airplane was substantially damaged. During the recovery of the airplane, when the master switch was turned on by the pilot, the landing gear dropped into the extended position. During interviews with the pilot, it was discovered that after the circuit breaker was reset, he did not continue with the "landing gear failure and manual gear extension" procedure, which was published in the Pilot's Operating Handbook for the accident airplane. A postaccident examination by a Federal Aviation Administration inspector revealed that the landing gear would extend and lock in the down position when the procedure was utilized.

Full narrative

Upon arrival at his destination airport, the pilot of a PA-30 attempted to extend his landing gear in preparation for landing. He discovered that one of the landing gear system circuit breakers had tripped. He attempted to reset the circuit breaker, but it would not reset. He then attempted to reset it a second time, which was successful, and he observed that the "green" landing gear down light was illuminated. During the landing roll, however, the landing gear collapsed and the airplane was substantially damaged. During the recovery of the airplane, when the master switch was turned on by the pilot, the landing gear dropped into the extended position. During interviews with the pilot, it was discovered that after the circuit breaker was reset, he did not continue with the "landing gear failure and manual gear extension" procedure, which was published in the pilot’s operating handbook for the accident airplane. A postaccident examination by a Federal Aviation Administration inspector revealed that the landing gear would extend and lock in the down position when the procedure was utilized.

Probable cause

The pilot's failure to follow the airplane manufacturer's landing gear failure and emergency extension procedures. Contributing to the accident was a malfunction of the landing gear system for undetermined reasons. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
60
Wind speed (kt)
6
Temperature (F)
79
Nearest airport
Jackson County Airport
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N7195Y — — SUBS 091

Sequence of events

#OccurrencePhase
1 Approach-VFR pattern downwind Sys/Comp malf/fail (non-power) Cruise
2 Landing-landing roll Landing gear collapse defining Cruise

Findings

Finding
Aircraft-Aircraft systems-Landing gear system-(general)-Incorrect use/operation cause
Aircraft-Aircraft systems-Landing gear system-(general)-Malfunction - F cause