N2572N accident

NTSB WPR09CA011 · 2008-10-12 · Fresno, CA · near E79

Docket — crew, injuries and powerplant

Summary

While on final for landing, the landing gear of the airplane struck a semi truck that was traveling on a road perpendicular to the runway at the approach end. The pilot had performed 10 full stop landings at the accident airport and was on approach for the 11th landing when the accident occurred. After impacting the trailer, the airplane landed on its belly and came to rest short of the runway. The pilot stated that the accident could have been prevented had he flown a higher approach. The driver and passenger in the vehicle stated that they had observed the airplane flying toward them and that it appeared low. Even though the airplane seemed low, the vehicle occupants thought it would clear the truck's trailer.

Full narrative

The pilot stated that he had been practicing for his commercial pilot check ride. He performed two landings at one airport, before departing to practice additional landings at another airport (the accident airport). After arrival at the accident airport, the pilot performed 10 full stop landings. While on approach for another landing (the accident), the pilot thought the winds seemed strong and he maneuvered for a crosswind landing. On short final the landing gear clipped the roof of a furniture truck’s trailer. The airplane landed on its belly and came to rest short of the runway.

In the Recommendation section of "how this accident/incident could have been prevented" of the National Transportation Safety Board Pilot/Operator Aircraft Accident/incident report (NTSB form 6120), the pilot stated that if he had flown a higher approach the accident could have been prevented.

According to a responding officer from the Fresno Police Department, the airport was oriented northwest to southeast, with a 4 lane road that is perpendicular to the airport. Airplanes have to crossover the road to land.

The driver and passenger of the furniture moving truck were traveling in a westbound direction at 50 miles per hour (mph), when they observed the airplane coming towards them. They reported that the airplane appeared too low to make the runway, but they did not think it unusual. The airplane struck the top forward portion of the truck's trailer.

A Federal Aviation Administration (FAA) inspector reported that the road is about 200 feet from the approach end of runway 30. A review of the flight school training program revealed under the safety rules section, the airport where the accident occurred, is considered "off-limits;" Sierra Sky Park Airport, Fresno, California. The flight school operates under 14 Code of Federal Regulations Part 141.

Probable cause

The pilot's failure to maintain a proper glide path while on final approach. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
300
Wind speed (kt)
10
Temperature (F)
64
Nearest airport
Sierra Sky Park Airport
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N2572N — — SUBS 091

Sequence of events

#OccurrencePhase
1 Approach-VFR pattern final Collision during takeoff/land defining Cruise

Findings

Finding
Environmental issues-Physical environment-Object/animal/substance-Ground vehicle-Contributed to outcome cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Glide-Not attained/maintained cause
Personnel issues-Action/decision-Action-Incorrect action performance-Pilot cause