N4659H accident

NTSB CEN09CA077 · 2008-11-30 · Pleasanton, TX · near PEZ

Docket — crew, injuries and powerplant

Summary

Prior to starting the engine, the pilot had tied down the airplane's tail on the ramp with a rope because no wheel chocks were available. After the pilot started the engine via hand turning the propeller, the rope that retained the airplane broke. The pilot attempted to hang onto the airplane in order to regain control, however, he was unsuccessful. The unoccupied airplane then struck a parked aircraft, a fence, and came to rest on its nose against the fence. The pilot was not injured.

Full narrative

Prior to starting the engine, the pilot had tied down the airplane's tail on the ramp with a rope because no wheel chocks were available. After the pilot started the engine via hand turning the propeller, the rope that retained the airplane broke. The pilot attempted to hang onto the airplane in order to regain control, however, he was unsuccessful. The unoccupied airplane then struck a parked aircraft, a fence, and came to rest on its nose against the fence. The pilot was not injured.

Probable cause

The pilot's failure to adequately secure the airplane while hand-starting the engine. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Ceiling (ft)
0
Wind direction
0
Nearest airport
Pleasanton Municipal Airport
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N4659H — — SUBS 091

Sequence of events

#OccurrencePhase
1 Prior to flight Aircraft servicing event Standing
2 Standing-engine(s) start-up Ground collision defining Standing

Findings

Finding
Personnel issues-Task performance-Planning/preparation-(general)-Pilot cause
Personnel issues-Action/decision-Action-Incorrect action selection-Pilot cause
Aircraft-Aircraft handling/service-Parking/securing-Tie-down/mooring-Incorrect service/maintenance cause