N175SJ accident

NTSB WPR09CA220 · 2009-04-30 · Arvin, CA

Docket — crew, injuries and powerplant

Summary

The pilot was on the last local aerial application flight of the day. Prior to starting the job, he flew above and around the field to check for obstructions and power lines. The field had numerous electrical feeder wires, with north-south power lines on the west and east ends of the 1/2-mile-long field. This application required the material be applied while making east-west passes above the feeder wires and oil pumps. Upon maneuvering onto the last eastbound pass, he applied aft cyclic to climb above the location of feeder wires. Several seconds later, he felt a sudden jarring and vibration emitting from the rear portion of the helicopter. He felt that he had possibly struck a wire that he did not see, and continued flying the helicopter in an eastbound direction to perform an emergency landing. As he began slowing, the front of the helicopter began yawing to the right in a southeast direction and it was headed towards a triple strand of east-west power lines and a small oil pump 25 feet south of the electrical lines. In anticipation of a second wire strike, he closed the throttle and began an autorotation prior to the helicopter striking the east-west power lines. It came to rest in an upright position facing in a southwest direction. He could hear the engine operating and performed emergency engine shutdown procedures. Visual examination revealed that the tail rotor made contact with the first set of power lines and separated along with its gearbox. The helicopter sustained substantial damage to the main rotor blades and fuselage after the second contact.

Full narrative

The pilot was on the last local aerial application flight of the day. Prior to starting the job, he flew above and around the field to check for obstructions and power lines. The field had numerous electrical feeder wires running throughout the job site, with north-south power lines on the west and east ends of the 1/2-mile-long field. This application required the material to be applied while making east-west passes above the feeder wires and oil pumps. Upon maneuvering onto the last eastbound pass, he applied aft cyclic to climb above the location of feeder wires. Several seconds later, he felt a sudden jarring and vibration emitting from the rear portion of the helicopter. He felt that he had possibly struck a wire that he did not see, and continued flying the helicopter in an eastbound direction to perform an emergency landing. As he began slowing, the front of the helicopter began yawing to the right in a southeast direction. It was headed towards a triple strand of east-west power lines and a small oil pump positioned approximately 25 feet south of the triple strand electrical lines. In anticipation of a second wire strike, he closed the throttle and began an autorotation prior to the helicopter striking the east-west power lines. It came to rest in an upright position facing in a southwest direction. He could hear the engine operating and performed emergency engine shutdown procedures. He exited the helicopter after all motion stopped, and met his field supervisor, who had already arrived and disconnected the aircraft battery. The tail rotor made contact with the first set of power lines and separated along with its gearbox. The helicopter sustained substantial damage to the main rotor blades and fuselage after the second contact.

Probable cause

The pilot’s failure to maintain clearance from wires during aerial application maneuvers. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
280
Wind speed (kt)
6
Temperature (F)
86
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N175SJ — — SUBS 137

Sequence of events

#OccurrencePhase
1 Maneuvering-low-alt flying Low altitude operation/event defining Climb

Findings

Finding
Environmental issues-Physical environment-Object/animal/substance-Wire-Awareness of condition cause
Personnel issues-Psychological-Attention/monitoring-Monitoring environment-Pilot cause