N2601 Aircraft Mfg & Development Co CH 601XL S accident

NTSB ERA09CA359 · 2009-06-20 · Vaughn, MS

Docket — crew, injuries and powerplant

Summary

An airline transport pilot was departing a private grass field in a special light sport airplane with a passenger onboard. With calm wind, the airplane began a takeoff roll to the west on an approximately 1000-foot-long turf runway. The pilot said that during the takeoff roll the airplane encountered a dip/bump in the runway, which reduced groundspeed and extended the ground roll. The airplane became airborne near the end of the runway, where it started to lose lift and struck an unseen wire with the right main landing gear. The wire was a solar/electrical wire, at a height of approximately 1 to 2 feet, which ran along an adjacent soybean patch. The airplane's nose then pitched down and the airplane came to rest at the bottom of a 5-foot embankment. The pilot reported that due to the density altitude and the weight of the airplane, he could not gain sufficient airspeed during the takeoff to climb. The pilot added that had the unseen wire not "snagged" the landing gear, the airplane would have been able to continue accelerating and climbing. The airplane received damage to the propeller, left leading edge of the left wing, the landing gear, and the fuselage. The pilot reported no preaccident mechanical deficiencies or mechanical problems with the airplane.

Full narrative

An airline transport pilot was departing a private grass field in a special light sport airplane, with a passenger onboard. With calm wind, the airplane began a takeoff roll to the west on an approximate 1000-foot-long turf runway. The pilot said that during the takeoff roll, the airplane encountered a dip/bump in the runway, which reduced groundspeed and extended the ground roll. The airplane became airborne near the end of the runway, where it started to lose lift and struck an unseen wire with the right main landing gear. The wire was a solar/electrical wire, at a height of approximately 1 to 2 feet, which ran along and adjacent soybean patch. The airplane's nose then pitched down and the airplane came to rest at the bottom of a 5-foot embankment. The pilot reported that due to the density altitude and the weight of the airplane, he could not gain sufficient airspeed during the takeoff to climb. The pilot added that had the unseen wire not "snagged" the landing gear, the airplane would have been able to continue accelerating and climbing. The airplane received damage to the propeller, left leading edge of the left wing, the landing gear, and the fuselage. The pilot reported no mechanical deficiencies or mechanical problems with the airplane.

Probable cause

The pilot's inadequate preflight planning. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Temperature (F)
95
Nearest airport
Private Airstrip
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N2601 AIRCRAFT MFG & DEVELOPMENT CO CH 601XL S SUBS 091

Sequence of events

#OccurrencePhase
1 Takeoff Abnormal runway contact Takeoff
2 Initial climb Collision during takeoff/land defining Takeoff

Findings

Finding
Personnel issues-Task performance-Planning/preparation-(general)-Pilot cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Climb rate-Not attained/maintained cause
Personnel issues-Experience/knowledge-Knowledge-Knowledge of geographic area-Pilot factor