N7660P accident
NTSB CEN09CA378 · 2009-06-20 · Urbana, OH · near I74
Docket — crew, injuries and powerplant
Summary
The pilot reported that during the engine run-up prior to the first flight of the day, he noted that there was no resistance on the control knob when he checked the operation of the carburetor heat and that there was a slightly “sluggish” return in the engine rpms as it returned to normal. The engine operated normally during this flight. When he applied carburetor heat during the engine run-up for the second flight of the day, he noticed that the rpm needle "wiggled down 50" then returned to the set rpm. Everything appeared normal during the takeoff until the airplane reached about 200 feet above the runway, when it felt a little “soggy.” The pilot stated that he raised the landing gear to reduce drag, but it did not seem like the engine was producing power. The pilot then extended the landing gear and decided to land the airplane in a field off the end of the runway. The landing gear, which was not locked down, collapsed during the landing and the left wing was substantially damaged when it contacted a runway end identifier light. Postaccident inspection of the airplane and engine revealed that the carburetor heat bracket between the valve shaft and the cable was fractured and missing. The carburetor heat valve was in the open position.
Full narrative
The pilot reported that during the engine run-up prior to the first flight of the day, he noted there was no resistance on the control knob when he checked the operation of the carburetor heat and there was a slightly “sluggish” return in the RPM as it returned to normal. The engine operated normally during this flight. When he applied carburetor heat during the engine run-up for the second flight of the day, he noticed “RPM needle wiggled down 50” then returned to the set RPM. Everything appeared normal during the takeoff until the airplane reached about 200 feet above the runway when it felt a little “soggy.” The pilot stated he raised the landing gear to reduce drag, but it did not seem like the engine was producing power. The pilot then extended the landing gear and decided to land the airplane in a field off the end of the runway. The landing gear, which was not locked down, collapsed during the landing and the left wing was substantially damaged when it contacted a runway end identifier light. Post accident inspection of the airplane and engine revealed the carburetor heat bracket between the valve shaft and the cable was fractured off and missing. The carburetor heat valve was in the open position.
Probable cause
A failure of the carburetor heat cable attach bracket which resulted in the inadvertent activation of carburetor heat and the subsequent loss of engine power during takeoff. Contributing to the accident was the pilot's operation of the aircraft with a known deficiency. The National Transportation Safety Board determined the probable cause of this accident.
Circumstances
- Event type
- Accident
- Highest injury
- None
- Weather conditions
- Visual Meteorological Cond
- Light condition
- Day
- Sky condition
- NONE
- Ceiling (ft)
- 0
- Visibility (sm)
- 9
- Wind direction
- 290
- Wind speed (kt)
- 9
- Temperature (F)
- 82
- Nearest airport
- Grimes Field Airport
- Distance from field
- 0.0
Aircraft
| Registration | Make | Model | Damage | FAR part |
|---|---|---|---|---|
| N7660P | — | — | SUBS | 091 |
Sequence of events
| # | Occurrence | Phase |
|---|---|---|
| 1 | Prior to flight Powerplant sys/comp malf/fail | Standing |
| 2 | Takeoff Loss of engine power (partial) defining | Takeoff |
| 3 | Landing-flare/touchdown Off-field or emergency landing | Cruise |
| 4 | Landing-flare/touchdown Landing gear collapse | Cruise |