N1934 Sidler Mike ROTORWAY accident

NTSB CEN09CA394 · 2009-06-27 · Waxahachie, TX · near KJWY

Docket — crew, injuries and powerplant

Summary

The private pilot was conducting a practice 180-degree power recovery autorotation in a helicopter with a clockwise rotating main rotor with a right crosswind of three knots. The pilot said he had a higher than expected rate of descent as he was flaring at zero airspeed and attempting a power recovery to terminate at a skid height of approximately 15 feet above ground level. Suddenly, and without warning the pilot lost directional control, the helicopter began to spin nose left, and his application of full right pedal had no effect. The pilot said he tried to keep the helicopter level while it was spinning, but it eventually impacted on the left side of the taxiway. The helicopter was substantially damaged when the left skid gear partially collapsed and the airframe and tail boom buckled. During the impact sequence the main rotor blades struck the tail boom and the main rotor blades and tail rotor blades struck the ground. An on-scene investigation by an FAA maintenance inspector confirmed flight control continuity and confirmed no apparent damage to the tail rotor drive belts. There was no post-crash fire and the pilot received minor injuries.

Full narrative

The private pilot was conducting a practice 180 degree power recovery autorotation in a helicopter with a clockwise rotating main rotor with a right crosswind of three knots. The pilot said he had a higher than expected rate of descent as he was flaring at zero airspeed and attempting a power recovery to terminate at a skid height of approximately 15 feet above ground level. Suddenly and without warning the pilot lost directional control, the helicopter began to spin nose left, and his application of full right pedal had no effect. The pilot said he tried to keep the helicopter level while it was spinning but it eventually impacted on the left side of the taxiway. The helicopter was substantially damaged when the left skid gear partially collapsed and the airframe and tail boom buckled. During the impact sequence the main rotor blades struck the tail boom and the main rotor blades and tail rotor blades struck the ground. An on-scene investigation by an FAA maintenance inspector confirmed flight control continuity and confirmed no apparent damage to the tail rotor drive belts. There was no post-crash fire and the pilot received minor injuries.

Probable cause

The pilot’s failure to control his rate of descent during autorotation, which required an aggressive recovery maneuver and resulted in a sudden loss of tail rotor effectiveness. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
250
Wind speed (kt)
3
Temperature (F)
95
Nearest airport
Mid-Way Regional Airport
Distance from field
0.0
Airport elevation
713

Aircraft

RegistrationMakeModelDamageFAR part
N1934 SIDLER MIKE ROTORWAY SUBS 091

Sequence of events

#OccurrencePhase
1 Landing-flare/touchdown Abrupt maneuver Cruise
2 Autorotation Loss of tail rotor effectiveness defining Descent
3 Landing Abnormal runway contact Cruise
4 Post-impact Landing gear collapse Approach

Findings

Finding
Personnel issues-Action/decision-Action-Delayed action-Pilot cause
Aircraft-Aircraft propeller/rotor-Tail rotor-(general)-Capability exceeded cause
Personnel issues-Experience/knowledge-Experience/qualifications-Total experience-Pilot factor
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Descent rate-Not attained/maintained cause
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause