N28938 accident

NTSB WPR10LA117 · 2010-01-22 · Shafter, CA

Docket — crew, injuries and powerplant

Summary

The pilot reported that he was maneuvering the helicopter to make an aerial application pass. At approximately 80 feet above ground level, he heard a muffled "crack/bang" and the helicopter immediately yawed and he experienced lateral vibrations in the cyclic. The pilot then initiated a forced landing with the shaking becoming more violent. The helicopter subsequently landed hard with the engine still running. The main rotor blades contacted and severed the tail boom, and the engine separated from its mounts. Postaccident examination of the helicopter revealed that a main rotor counterweight was missing. Examination of the broken counterweight rod end showed evidence of corrosion over approximately 45 percent of the diameter of the rod end. Maintenance records indicate that a Service Bulletin to inspect main rotor counterweight rods for pit corrosion had not been complied with. The Service Bulletin states that after an initial inspection of the main rotor counterweight rods, recurrent inspections should be accomplished every 300 hours of time in service.

Full narrative

On January 22, 2010, approximately 0909 Pacific standard time, a Bell 47G-4A helicopter, N28938, sustained substantial damage following a forced landing near Shafter, California. The commercial pilot, the sole occupant, received minor injuries. Inland Crop Dusters, Inc., was operating the helicopter under the provisions of 14 Code of Federal Regulations Part 137. Visual meteorological conditions prevailed for the aerial application flight. A flight plan had not been filed.

The pilot reported that while maneuvering at 80 feet to make an aerial application run, he heard a muffled "crack/bang." The helicopter immediately yawed and the pilot experienced lateral vibrations in the cyclic. He initiated a forced landing to the field below and the shaking became more "violent." He said the engine was still running, but the aircraft landed hard. The main rotor blades contacted and severed the tail boom, and the engine separated from its mounts.

A post accident examination of the helicopter by a Federal Aviation Administration inspector revealed that a main rotor blade counterweight was missing. There was a search for the missing part, but it was never located. Examination of the broken counterweight rod end showed evidence of corrosion over approximately 45 percent of the diameter of the rod end. Maintenance records indicate the rod was not inspected for corrosion pits to comply with Bell Helicopter Textron Service Bulletin 47-78-2 Rev. B, April 13, 1981. The Service Bulletin states that after an initial inspection for corrosion pits on the counterweight rods, recurrent inspections will be accomplished every 300 hours of time in service.

Probable cause

The loss of a main rotor blade counterweight due to corrosion. Contributing to the accident was the failure of the operator to perform the initial and recurrent inspections required by a Service Bulletin to detect the corrosion in the counterweight. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
BKN
Ceiling (ft)
4400
Visibility (sm)
10
Wind direction
90
Wind speed (kt)
7
Temperature (F)
46
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N28938 — — SUBS 137

Sequence of events

#OccurrencePhase
1 Prior to flight Aircraft maintenance event Standing
2 Maneuvering Part(s) separation from AC Climb
3 Landing-flare/touchdown Hard landing defining Cruise

Findings

Finding
Aircraft-Aircraft systems-Flight control system-(general)-Failure cause
Personnel issues-Task performance-Inspection-(general)-Maintenance personnel - F cause