N4282 accident

NTSB WPR10CA164 · 2010-03-16 · Parker, AZ · near AZ47

Docket — crew, injuries and powerplant

Summary

The pilot of the helicopter told the lead mechanic that the main rotor blade needed to be balanced. Two mechanics showed up on the morning of the accident and installed the balancing equipment. A test flight was flown. The two men performed the necessary work, which required a second adjustable wrench on the top of the rotor head to hold the bolt while the nut below was removed and later torqued back on. When the work was finished, the men gathered their tools. The pilot asked the lead mechanic if they had gathered all their tools and the mechanic replied "yes." The three men got on the helicopter for a test hover to check their work. As the main rotor speed reach 100 percent, the three occupants heard a "bang." As the helicopter hovered, the two mechanics thought the balancing equipment readings were worse than the first flight, and the vibrations in the aircraft had increased. The pilot landed the helicopter so that the mechanics could make additional adjustments. The mechanics discovered that they were missing the adjustable wrench that had been used on the top of the main rotor head. Postaccident examination revealed that one main rotor blade, the tail boom, and the lower vertical stabilizer had received damage from the unaccounted for wrench.

Full narrative

The pilot of the helicopter told the lead mechanic that the main rotor blade needed to be balanced. Two mechanics showed up on the morning of the accident and installed the balancing equipment. A test flight was flown. The two men performed the necessary work, which required a second adjustable wrench on the top of the rotor head to hold the bolt while the nut below was removed and later torqued back on. When the work was finished, the men gathered their tools. The pilot asked the lead mechanic if they had gathered all their tools and the mechanic replied "yes." The three men got on the helicopter for a test hover to check their work. As the main rotor speed reach 100 percent, the three occupants heard a "bang." As the helicopter hovered, the two mechanics thought the balancing equipment readings were worse than the first flight, and the vibrations in the aircraft had increased. The pilot landed the helicopter so the mechanics could make additional adjustments. The mechanics discovered that they were missing the adjustable wrench that had been used on the top of the main rotor head. Post accident examination revealed that one main rotor blade, the tail boom, and the lower vertical stabilizer had received damage from the unaccounted for wrench.

Probable cause

The mechanics' failure to account for all the tools following a maintenance procedure and the pilot's failure to perform a preflight check before a maintenance test flight. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
50
Wind speed (kt)
5
Temperature (F)
70
Nearest airport
Lapaz Regional Hospital Helpt
Distance from field
0.0
Airport elevation
450

Aircraft

RegistrationMakeModelDamageFAR part
N4282 — — SUBS 091

Sequence of events

#OccurrencePhase
1 Prior to flight Aircraft maintenance event Standing
2 Prior to flight Aircraft inspection event Standing
3 Maneuvering-hover Miscellaneous/other defining Climb

Findings

Finding
Personnel issues-Task performance-Maintenance-Scheduled/routine maintenance-Maintenance personnel cause
Personnel issues-Task performance-Inspection-Preflight inspection-Pilot cause
Environmental issues-Physical environment-Object/animal/substance-Debris/dirt/foreign object-Effect on equipment factor