N7925Y accident

NTSB ERA10CA183 · 2010-03-17 · Baltimore, MD · near MTN

Docket — crew, injuries and powerplant

Summary

The pilot stated that he accumulated 26 hours of flight time in the accident airplane about 2 years prior to the accident, but had not flown the accident airplane since. About 1 week prior to the accident, the pilot obtained his airplane multiengine rating in a different make and model than the accident airplane. The pilot stated that the purpose of the accident flight was to perform full-stop landings in order to familiarize himself with the airplane. While on the downwind leg of the traffic pattern for the first landing, he was cleared by the air traffic control tower for a "touch-and-go." After the airplane touched down, the pilot applied full power, and intended to retract the wing flaps, but inadvertently retracted the landing gear instead. The landing gear "immediately" collapsed, and the airplane slid to a stop on its underside. Both wings were substantially damaged. The pilot stated there were no mechanical malfunctions or failures, and that the accident might have been prevented if he had declined the touch-and-go landing, and had taken time to become more familiar with the locations of the landing gear and flap controls. He also stated that he had recently trained in an airplane with a "different layout," and his "sense memory for the controls was wrong."

Full narrative

The pilot stated that he accumulated 26 hours of flight time in the accident airplane about 2 years prior to the accident, but had not flown the accident airplane since. About 1 week prior to the accident, the pilot obtained his airplane multiengine rating in a different make and model than the accident airplane. The pilot stated that the purpose of the accident flight was to perform full-stop landings in order to familiarize himself with the airplane. While on the downwind leg of the traffic pattern for the first landing, he was cleared by the air traffic control tower for a "touch-and-go." After the airplane touched down, the pilot applied full power, and intended to retract the wing flaps, but inadvertently retracted the landing gear instead. The landing gear "immediately" collapsed, and the airplane slid to a stop on its underside. Both wings were substantially damaged. The pilot stated there were no mechanical malfunctions or failures, and that the accident might have been prevented if he had declined the touch-and-go landing, and had taken time to become more familiar with the locations of the landing gear and flap controls. He also stated that he had recently trained in an airplane with a "different layout," and his "sense memory for the controls was wrong."

Probable cause

The pilot's inadvertent retraction of the landing gear during a touch-and-go landing. Contributing to the accident was the pilot's lack of recent experience in the make and model airplane. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
350
Wind speed (kt)
5
Temperature (F)
55
Nearest airport
Martin State
Distance from field
0.0
Airport elevation
21

Aircraft

RegistrationMakeModelDamageFAR part
N7925Y — — SUBS 091

Sequence of events

#OccurrencePhase
1 Takeoff Landing gear collapse defining Takeoff

Findings

Finding
Aircraft-Aircraft systems-Landing gear system-Gear extension and retract sys-Unintentional use/operation cause
Personnel issues-Action/decision-Action-Incorrect action performance-Pilot cause
Personnel issues-Experience/knowledge-Experience/qualifications-Recent experience w/ equipment-Pilot - F cause