N93876 Univair Aircraft Corporation 415-C accident

NTSB CEN10LA203 · 2010-04-12 · Columbiaville, MI

Docket — crew, injuries and powerplant

Summary

The pilot reported that he landed approximately a third of the way down the runway. He said that as he applied the brakes near the turnabout area at the south end of the runway, he discovered that he couldn't stop. The airplane subsequently went down an embankment, struck terrain, and sustained substantial damage. Postaccident examination of the wreckage revealed that the brake master cylinder piston rod's clevis had separated. An NTSB materials laboratory examination indicated that the separation was consistent with bending forces associated with the accident and no preexisting anomalies were detected.

Full narrative

On April 12, 2010, about 1130 eastern daylight time, a Univair Aircraft Corporation 415-C, N93876, piloted by a private pilot, exited runway 18 (1,400 feet by 80 feet, dry grass) while landing at private airstrip near Columbiaville, Michigan. The airplane subsequently sustained substantial damage on impact with terrain. Visual meteorological conditions prevailed at the time of the accident. The 14 CFR Part 91 personal flight was not operating on a flight plan. The pilot was uninjured. The flight originated about 1100 from the Wm 'Tiny' Zehnder Field Airport, near Frankenmuth, Michigan, and was destined for the private airstrip.

The pilot, in his accident report, said he'd set up for a normal approach to runway 18 and landed approximately a third of the way down the runway. He said that as he applied the brakes near the turnabout area at the south end of the runway, he discovered that he couldn't stop. He went off the end of the runway and down an embankment causing considerable damage to the airplane. The pilot said that "later when the FAA [Federal Aviation Administration] inspector arrived, we discovered that the brake pedal had broken ..."

An examination of the brake master cylinder piston rod’s clevis was found separated from its piston rod. The separated clevis was retained by the FAA inspector and forwarded to the National Transportation Safety Board (NTSB) for further examination at the materials laboratory.

A Senior Materials Engineer examined the separated clevis and reported that the fracture surface had rough matte gray fracture features consistent with an overstress fracture. Their report stated that overall fracture features including radial marks and contact faces that were consistent with fracture under bending loads with the upper end bending forward and to the right relative to the lower end. No evidence of any preexisting damage such as fatigue was observed.

Probable cause

The pilot misjudged his speed and distance while landing, which resulted in an overrun and subsequent collision with terrain. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
60
Wind speed (kt)
7
Temperature (F)
55
Distance from field
1.0

Aircraft

RegistrationMakeModelDamageFAR part
N93876 Univair Aircraft Corporation 415-C SUBS 091

Sequence of events

#OccurrencePhase
1 Landing Loss of control on ground defining Cruise
2 Landing Runway excursion Cruise

Findings

Finding
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-(general)-Not attained/maintained cause
Environmental issues-Physical environment-Terrain-Sloped/uneven-Contributed to outcome factor
Personnel issues-Action/decision-Info processing/decision-Decision making/judgment-Pilot cause