N301TW accident

NTSB CEN10CA376 · 2010-07-03 · Wellington, CO · near 4CO2

Docket — crew, injuries and powerplant

Summary

The pilot, who is also the designer and builder of the experimental motorglider, was making his second flight after having completed a number of high-speed taxi tests. The pilot said that several months earlier, on his first flight in the motorglider, shortly after becoming airborne the engine experienced a partial loss of power and he landed immediately. On the accident flight, immediately after takeoff, the pusher-configuration engine again lost power from 6,500 rpm to approximately 4,300 rpm. The pilot was not able to climb and was able to maintain flight at only 100 feet above ground level. Approximately one mile from the airport the pilot attempted an off-field emergency landing and then “did an intentional ground loop” to avoid a fence he had not noticed before touchdown. With the motorglider then moving sideways, the tail impacted a small tree. The carbon-fiber tail boom fractured and separated just forward of the vertical fin, causing substantial damage to the motorglider. The solo pilot was not injured. The pilot reported that there was adequate fuel in the tank and previous testing showed there was adequate fuel flow to the engine. After the accident the pilot reported that that his design of the engine cowling needed to be modified and he thought that “an engine compartment pressure differential from outside air caused the carburetor float bowl to empty.”

Full narrative

The pilot, who is also the designer and builder of the experimental motorglider, was making his second flight after having completed a number of high-speed taxi tests. The pilot said that several months earlier, on his first flight in the motorglider, shortly after becoming airborne the engine experienced a partial loss of power and he landed immediately. On the accident flight, immediately after takeoff, the pusher-configuration engine again lost power from 6,500 rpm to approximately 4,300 rpm. The pilot was not able to climb and was able to maintain flight at only 100 feet above ground level. Approximately one mile from the airport the pilot attempted an off-field emergency landing and then “did an intentional ground loop” to avoid a fence he had not noticed before touchdown. With the motorglider then moving sideways, the tail impacted a small tree. The carbon-fiber tail boom fractured and separated just forward of the vertical fin, causing substantial damage to the motorglider. The solo pilot was not injured. The pilot reported that there was adequate fuel in the tank and previous testing showed there was adequate fuel flow to the engine. After the accident the pilot reported that that his design of the engine cowling needed to be modified and he thought that “an engine compartment pressure differential from outside air caused the carburetor float bowl to empty.”

Probable cause

A partial loss of engine power due to the inadequate design of the engine cowling. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
130
Wind speed (kt)
11
Temperature (F)
91
Nearest airport
Owl Canyon Gliderport
Distance from field
1.0
Airport elevation
5545

Aircraft

RegistrationMakeModelDamageFAR part
N301TW — — SUBS 091

Sequence of events

#OccurrencePhase
1 Prior to flight Miscellaneous/other Standing
2 Takeoff Loss of engine power (partial) defining Takeoff
3 Emergency descent Off-field or emergency landing Descent
4 Landing-landing roll Collision with terr/obj (non-CFIT) Cruise
5 Post-impact Aircraft structural failure Approach

Findings

Finding
Aircraft-Aircraft power plant-Engine (reciprocating)-(general)-Design cause