N5281R accident

NTSB CEN10LA414 · 2010-07-14 · Mount Cory, OH

Docket — crew, injuries and powerplant

Summary

The pilot reported that he heard what sounded like an explosion in the rear of the airplane during cruise flight at 3,000 feet. He stated that the airplane then began to vibrate and it sounded as if something was banging on the airplane. The pilot reported he chose a street on which to make a precautionary landing and that the elevator was ineffective during the landing flare. The airplane touched down hard, bounced, and veered off the side of the road where it contacted two concrete posts prior to nosing over. A post accident inspection revealed that 26 of the Avex rivets on the aft bulkhead had failed/worked out allowing the several sections of the aft fuselage skin to pop up. The inspection also revealed that “smoking” was visible around some of the rivet holes indicating that the rivets were loose. When the pilot purchased the unfinished airplane, the riveting had already been accomplished. The kit manufacturer calls for Avex rivets to be used. The partial separation of the skin from the bulkhead allowed the empennage to flex which most could have resulted in the lack of elevator control during the landing.

Full narrative

On July 14, 2010, at 1230 eastern daylight time, an amateur built experimental Wogenstahl 281 MR, N5281R, collided with concrete posts and nosed over during an off airport precautionary landing following an in-flight structural failure. The pilot and passenger were not injured. The airplane was substantially damaged. The Title 14 Code of Federal Regulations Part 91 personal flight was operating in visual meteorological conditions without a flight plan. The flight departed from Middletown, Ohio, at 1030 with an intended destination of Bowling Green, Ohio.

The pilot reported that he heard what sounded like an explosion in the rear of the airplane during cruise flight at 3,000 feet. He stated the airplane then began to vibrate and it sounded as if something was banging on the airplane. The pilot reported he chose a street on which to make a precautionary landing and that the elevator was ineffective during the landing flare. The airplane touched down hard, bounced, and veered off the side of the road where it contacted two concrete posts prior to nosing over.

The pilot reported that the riveting had already been accomplished when he purchased the unfinished airplane from a previous owner. The post accident inspection by a Federal Aviation Administration Inspector and the pilot revealed that 26 of the Avex rivets on the aft bulkhead had failed/worked out allowing the several sections of the aft fuselage skin to pop up. The inspection also revealed that “smoking” was visible around some of the rivet holes indicating that the rivets were loose. The kit manufacturer does call for Avex rivets to be used. The inspector stated that the partial separation of the skin from the bulkhead allowed the empennage to flex which would have resulted in the lack of elevator control during the landing.

Probable cause

The improper installation of the rivets at the aft fuselage bulkhead which resulted in the pilot not having full elevator control on landing. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Temperature (F)
81
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N5281R — — SUBS 091

Sequence of events

#OccurrencePhase
1 Enroute Aircraft structural failure defining Climb
2 Landing-flare/touchdown Flight control sys malf/fail Cruise
3 Landing-flare/touchdown Loss of control in flight Cruise
4 Landing-flare/touchdown Hard landing Cruise
5 Landing-landing roll Collision with terr/obj (non-CFIT) Cruise
6 Landing-landing roll Nose over/nose down Cruise

Findings

Finding
Aircraft-Aircraft structures-Fuselage-Fuselage attach fittings sys-Failure cause
Aircraft-Aircraft structures-Fuselage-Fuselage attach fittings sys-Not specified cause
Personnel issues-Task performance-Maintenance-Installation-Not specified cause
Environmental issues-Physical environment-Object/animal/substance-Sign/marker-Contributed to outcome - F cause