N320CY Yeager Inc. Lancair accident

NTSB ERA10CA461 · 2010-09-02 · McMinnville, TN · near RNC

Docket — crew, injuries and powerplant

Summary

The pilot stated that he taxied to the runway for the purpose of performing a high speed taxi run. After an engine run-up, he latched the two canopy latches on the right side and scanned the instrument panel, noticing that the cylinder head temperature and oil temperature were rising. He stated that his attention was diverted in concern of the rising temperature and did not recall if he latched the two latches on the left side of the canopy. He started the takeoff roll and after becoming airborne, he noticed the canopy opening on the left side. The pilot attempted to latch the canopy, but realized it would take both hands, and continued to climb to pattern altitude while trimming the aircraft for better airspeed control. He then pulled the throttle back to slow the airspeed and attempted to latch the canopy. The canopy started flapping up and down, and when he tried to secure it shut with his hands he was not be able to control the airplane. He stated that debris was flying everywhere and the wind blew off his headset. When he realized that he was getting low he added full engine power and looked for a clear area; shortly thereafter the airplane collided with the ground.

Full narrative

The pilot stated that he taxied to the runway to do a high speed taxi run. He performed an engine run up, and while doing a magneto test he noticed the engine was running rich and leaned the mixture and retested the magnetos. All was okay, so he continued with the check list. At this point he latched the two canopy latches on the right side and scanned the instrument panel and noticed that the head temperature and oil temperature rising. He stated that his attention was diverted in concern of the rising head temperature and did not recall if he latched the two latches on the left side of the canopy. He started the takeoff roll and after becoming airborne and climbing, he noticed the canopy coming up on the left side. The pilot attempted to latch the canopy, but realized it would take both hands, and continued to climb to pattern altitude while trimming the aircraft for better airspeed control. He then pulled the throttle back to slow down and to try to shut the canopy. The canopy started flapping up and down, and the pilot tried to hang on to the canopy, but that was causing him to not be able to control the airplane. He stated that debris was flying everywhere and the wind blew off his headset. When he realized that he was getting low he added full power and looked for a clear area. The next thing he knew was that the airplane hit the ground.

Probable cause

The pilot’s failure to properly latch the cockpit canopy prior to takeoff, resulting in his diverted attention and failure to maintain aircraft control. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Wind speed (kt)
4
Temperature (F)
91
Nearest airport
Warren County Memorial Airport
Distance from field
1.0
Airport elevation
1032

Aircraft

RegistrationMakeModelDamageFAR part
N320CY Yeager Inc. Lancair SUBS 091

Sequence of events

#OccurrencePhase
1 Initial climb Miscellaneous/other defining Takeoff
2 Initial climb Loss of control in flight Takeoff
3 Uncontrolled descent Collision with terr/obj (non-CFIT) Descent

Findings

Finding
Personnel issues-Action/decision-Action-Forgotten action/omission-Pilot cause
Aircraft-Aircraft structures-Windows-windshield system-Flight compartment windows-Incorrect use/operation cause