N471B Rotherwick Glasair III accident

NTSB WPR11CA022 · 2010-10-21 · Colville, WA · near 635

Docket — crew, injuries and powerplant

Summary

The pilot reported that he was landing the airplane in calm wind conditions. The airplane touched down midway down the runway at stall speed. Upon touchdown, the pilot retracted the flaps and applied brake pressure, including full aft elevator, in an attempt to bring the airplane to a stop. With the end of the runway approaching, the pilot applied left brake in an effort to turn the airplane to the left and the airplane nosed over off the end of the runway. The pilot stated that he checked the brakes prior to flight, but felt that they did not function normally during the landing. A witness reported that when the airplane was landing, it floated in ground effect until about 100 feet beyond midfield. The landing gear contacted the runway and the airplane continued to decelerate until disappearing over the end of the runway. According to a Federal Aviation Administration (FAA) inspector that responded to the accident, skid marks led from the runway to the location where the airplane came to rest. The FAA inspector examined the braking system following the accident and found no mechanical anomalies. At the time of this writing, the pilot had not submitted NTSB Form 6120.1, the Pilot/Operator Aircraft Accident/Incident Report.

Full narrative

The pilot reported in a written statement that he was landing the airplane to the south on a 2,695-foot long runway, with winds from the south at 1-2 knots. The airplane touched down midfield at stall speed. Upon touchdown, the pilot retracted the flaps and applied moderate brake pressure, including full aft elevator to bring the airplane to a stop. With the end of the runway approaching, the pilot applied maximum brake pressure. Near the end of the runway the pilot applied left brake to turn the airplane to the left, and the airplane nosed over off the end of the runway. The pilot stated that he checked the brakes prior to flight, but felt that they did not function normally during the landing. A witness reported that when the airplane was landing, it floated in ground effect until about 100 feet beyond midfield. The landing gear contacted the runway, and the airplane continued to decelerate until disappearing over the end of the runway. According to the FAA inspector, skid marks led from the runway to the location where the airplane came to rest. The FAA inspector examined the braking system following the accident and found no mechanical anomalies. At the time of this report, the pilot had not submitted NTSB Form 6120.1, the Pilot/Operator Aircraft Accident/Incident Report.

Probable cause

The pilot's misjudged approach and failure to attain the proper touchdown point, which resulted in a runway overrun. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Temperature (F)
52
Nearest airport
Colville Municipal
Distance from field
0.0
Airport elevation
1882

Aircraft

RegistrationMakeModelDamageFAR part
N471B Rotherwick Glasair III SUBS 091

Sequence of events

#OccurrencePhase
1 Landing-flare/touchdown Landing area overshoot Cruise
2 Landing-landing roll Runway excursion defining Cruise

Findings

Finding
Aircraft-Aircraft oper/perf/capability-Aircraft capability-Landing distance-Not attained/maintained cause
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause
Environmental issues-Operating environment-Airport facilities/design-Runway/landing area length-Response/compensation factor
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Descent/approach/glide path-Not attained/maintained cause