N5706D accident
NTSB ERA11CA108 · 2011-01-06 · Thomaston, GA · near OPN
Docket — crew, injuries and powerplant
Summary
According to the pilot, the airplane had returned to service after being restored by an airframe and powerplant mechanic with inspection authorization. The pilot performed several takeoffs and landings prior to the accident flight, and noted that the airplane seemed to operate normally. The pilot departed to another airport where he completed a simulated instrument approach to about 50 feet above the runway. He then commenced a go-around over the departure end of the runway with the airplane about 300 feet above the ground. The engine experienced a partial loss of power and the pilot maneuvered the airplane a hay field, where he performed a forced landing. During the landing roll, the horizontal stabilizer struck a hay bale resulting in substantial damage to the empennage. A postaccident examination of the wreckage by a Federal Aviation Administration inspector revealed that a cotter pin was not installed on the throttle arm retaining nut. The throttle arm retaining nut was finger tight and the throttle arm was loose, which resulted in excessive play in the throttle linkage.
Full narrative
According to the pilot, the airplane had returned to service after being restored by a licensed airframe and powerplant mechanic with inspection authorization. The pilot performed several takeoffs and landings prior to the accident flight, and the airplane seemed normal. The pilot subsequently took off again and flew to another airport where he completed a simulated instrument approach to about 50 feet above the runway. He then commenced a go around and was over the departure end of the runway, about 300 feet above the ground, when the engine had a partial power loss. The pilot maneuvered the airplane to a forced landing in a hay field, and during the landing roll, the horizontal stabilizer struck a hay bale resulting in substantial damage to the empennage. A subsequent examination of the wreckage by a Federal Aviation Administration inspector revealed that a cotter pin was not installed on the throttle arm retaining nut. The throttle arm retaining nut was finger tight and the throttle arm was loose.
Probable cause
The mechanic's failure to install a cotter retaining pin in the throttle arm retaining nut resulting in excessive throttle play and loss of engine power control. The National Transportation Safety Board determined the probable cause of this accident.
Circumstances
- Event type
- Accident
- Highest injury
- None
- Weather conditions
- Visual Meteorological Cond
- Light condition
- Day
- Sky condition
- NONE
- Ceiling (ft)
- 0
- Visibility (sm)
- 10
- Wind direction
- 280
- Wind speed (kt)
- 10
- Temperature (F)
- 48
- Nearest airport
- Thomaston-Upson County Airport
- Distance from field
- 1.0
- Airport elevation
- 798
Aircraft
| Registration | Make | Model | Damage | FAR part |
|---|---|---|---|---|
| N5706D | — | — | SUBS | 091 |
Sequence of events
| # | Occurrence | Phase |
|---|---|---|
| 1 | Approach-VFR go-around Loss of engine power (partial) defining | Cruise |
| 2 | Emergency descent Off-field or emergency landing | Descent |
| 3 | Landing-landing roll Ground collision | Cruise |