N8053R Harvey Patten RANS S-6ES accident
NTSB WPR11CA112 · 2011-01-28 · Buckeye, AZ · near BXK
Docket — crew, injuries and powerplant
Summary
While in cruise flight the pilot realized that he had lost elevator control. The pilot attempted to determine if there was any way to reestablish elevator control but was unsuccessful. He was able to maintain pitch control by increasing or decreasing engine power. During a precautionary landing the airplane impacted the runway hard and sustained substantial damage to the firewall. On-scene inspection of the aircraft’s elevator control system revealed that the bolt that connects the aft elevator push-pull control tube to the pilot and copilot's control stick bellcrank was missing, and was not found during a thorough inspection of the area. In addition, the bolt that connects the forward push-pull tube to the control stick bellcrank was ready to fall out. These bolts are an AN-type drilled shank bolt requiring a castellated nut and cotter pin for security. Neither of the nuts or cotter pins were found. The aircraft had 197 hours total time. The last condition inspection was performed 2 months and 24 operating hours prior to the accident. It could not be determined if the cotter pin had ever been installed.
Full narrative
While in cruise flight the pilot realized he had lost elevator control. The pilot attempted to determine if there was any way to re-establish elevator control but was unsuccessful. He was able to maintain pitch control by increasing or decreasing engine power. During a precautionary landing the airplane was damaged when it impacted the runway hard and damaged the firewall. On scene inspection of the aircraft’s elevator control system by an FAA Airworthiness Inspector revealed the bolt that connects the aft elevator push pull control tube to the pilot and copilot's control stick bellcrank was missing, and was not found during a thorough inspection of the area. In addition, the bolt that connects the forward push pull tube to the control stick bellcrank was ready to fall out. These bolts are an AN type drilled shank bolt requiring a castellated nut and cotter pin for security. Neither of the nuts or cotter pins were found. The aircraft has 197 hours total time. The last condition inspection was performed 2 months and 24 operating hours prior to the accident. It could not be determined if the cotter pin had ever been installed.
Probable cause
A disconnection of the elevator control linkage due to incorrect installation or maintenance, which was due to the retaining nut backing off the bolt and allowing the bolt to fall out. The National Transportation Safety Board determined the probable cause of this accident.
Circumstances
- Event type
- Accident
- Highest injury
- Minor
- Weather conditions
- Visual Meteorological Cond
- Light condition
- Day
- Sky condition
- NONE
- Ceiling (ft)
- 0
- Visibility (sm)
- 10
- Wind direction
- 130
- Wind speed (kt)
- 6
- Temperature (F)
- 72
- Nearest airport
- Buckeye Municipal Airport
- Distance from field
- 0.0
- Airport elevation
- 1033
Aircraft
| Registration | Make | Model | Damage | FAR part |
|---|---|---|---|---|
| N8053R | HARVEY PATTEN | RANS S-6ES | SUBS | 091 |
Sequence of events
| # | Occurrence | Phase |
|---|---|---|
| 1 | Prior to flight Aircraft maintenance event | Standing |
| 2 | Enroute-cruise Sys/Comp malf/fail (non-power) defining | Climb |
| 3 | Enroute-cruise Loss of control in flight | Climb |
| 4 | Landing Runway excursion | Cruise |
Findings
| Finding | |
|---|---|
| Aircraft-Aircraft systems-Flight control system-Elevator control system-Malfunction | cause |