N614S D & D Aircraft ROTORWAY EXEC accident

NTSB CEN11LA305 · 2011-04-23 · Massillon, OH

Docket — crew, injuries and powerplant

Summary

The pilot reported that during cruise flight the engine speed increased to a high rpm and power was no longer being transmitted to the rotor system. He initiated an autorotation to a sloping, plowed field that was soft due to recent rain. The tail struck the ground during the landing flare and the main rotor blades contacted the tailboom. Postaccident inspection of the helicopter revealed the inner race of the bearing on the secondary shaft, located above the transmission clutch, was worn into the shaft, which most likely caused the clutch to disengage. This prevented the engine power from being translated to the main rotor. The cause of the wear was undetermined, and the secondary shaft was designed by the pilot.

Full narrative

On April 23, 2011, at 1541 eastern daylight time, a D&D Aircraft Rotorway Exec, N614S, an experimental, amateur built helicopter, collided with the terrain during an off airport forced landing in Massillon, Ohio. The pilot received a minor injury while exiting the helicopter. The helicopter received substantial damage. The personal flight was being operated under 14 Code of Federal Regulations Part 91. Visual meteorological conditions prevailed and no flight plan was filed. The local flight originated from a private field in Massillon, Ohio.

The pilot reported that during cruise flight the engine speed increased to a high rpm and the power was no longer being transmitted through to the rotor system. He initiated an autorotation to a sloping, plowed field that was soft due to recent rain. The tail struck the ground during the landing flare and the main rotor blades contacted the tailboom. The helicopter rolled over due to the downward slope and the soft terrain.

Postaccident inspection of the helicopter by the pilot/builder and Federal Aviation Administration inspectors revealed the inner race of the bearing on the secondary shaft, located above the transmission clutch, was worn into the shaft. The secondary shaft was designed by the pilot.

Probable cause

The excessive wear on the secondary shaft, from the inner bearing race, which resulted in the transmission clutch disengagement and a loss of power to the rotor system. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
BKN
Ceiling (ft)
3600
Visibility (sm)
8
Wind direction
230
Wind speed (kt)
21
Temperature (F)
70
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N614S D & D AIRCRAFT ROTORWAY EXEC SUBS 091

Sequence of events

#OccurrencePhase
1 Enroute-cruise Loss of engine power (partial) defining Climb
2 Landing-flare/touchdown Collision with terr/obj (non-CFIT) Cruise

Findings

Finding
Aircraft-Aircraft propeller/rotor-Main rotor drive-(general)-Failure cause