N2077E accident

NTSB CEN11LA397 · 2011-06-15 · Grand Forks, ND

Docket — crew, injuries and powerplant

Summary

The certified flight instructor (CFI) and student were performing a simulated forced landing which was to terminate with power. The student flared about 50 feet above the ground while the CFI monitored the rotor and engine rpm. The student used the collective to reduce the forward speed and rate of descent, and the engine rpm was increased to recover from the autorotation. The CFI reported that the helicopter was slightly tail-low, and it yawed slightly as the power was increased. The CFI took over the controls to level the skids and straighten the heading as the helicopter continued to sink. The helicopter continued to descend making a “light touch down” and run-on landing. The CFI reported that during the level-off and ground contact, they heard a metal-on-metal type of sound. A postaccident inspection of the helicopter revealed two of the main rotor blades had contacted the tailboom.

Full narrative

On June 15, 2011, at 1450 central daylight time, a Schweizer 269C, N2077E, operated by the University of North Dakota, sustained substantial damage to the tailboom while recovering from a practice autorotation in Grand Forks, North Dakota. The certified flight instructor and the student pilot were not injured. The 14 Code of Federal Regulations Part 91 instructional flight was operating in visual meteorological conditions without a flight plan. The local flight originated from the Grand Forks International Airport (GFK), Grand Forks, North Dakota, at 1430.

The flight instructor and student were performing a simulated forced landing which was to terminate with power when the accident occurred. The student lowered the collective to enter the autorotation and set the trim and pitch to maintain the recommended airspeed. The instructor adjusted the collective during the autorotation in order to prevent an overspeed and the student began the flare at an altitude of about 50 feet above the ground. The instructor stated the rotor revolutions per minute (rpm) were within the green arc and the engine was at 2,600 rpm.

The student used the collective to reduce the forward speed and rate of descent. The engine power was then increased to recover from the autorotation and the instructor noted the engine rpm needle moving up through 3,000 rpm. The instructor reported the helicopter was slightly tail low and it yawed slightly as the power was increased. The instructor took over the controls to level the skids and straighten the heading as the helicopter continued to sink. The helicopter continued to descend making a “light touch down” and run-on landing. The instructor reported that during the level-off and ground contact, they heard a metal on metal type sound.

Postaccident inspection of the helicopter revealed two of the main rotor blades had contacted the tailboom.

The helicopter was equipped with a Appareo RMS-2000 flight data recorder. The data downloaded from the recorder is included in the docket for this report.

Probable cause

The student pilot's inadequate recovery from an autorotation and the CFI's delayed remedial action. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
OVC
Ceiling (ft)
4900
Visibility (sm)
10
Wind direction
0
Wind speed (kt)
0
Temperature (F)
66
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N2077E — — SUBS 091

Sequence of events

#OccurrencePhase
1 Autorotation Loss of control in flight defining Descent
2 Autorotation Collision with terr/obj (non-CFIT) Descent

Findings

Finding
Personnel issues-Task performance-Use of equip/info-Aircraft control-Student pilot cause
Personnel issues-Action/decision-Action-Delayed action-Instructor/check pilot cause