N99136 accident

NTSB ERA11CA350 · 2011-06-16 · Sterling, MA · near 3B3

Docket — crew, injuries and powerplant

Summary

According to the pilot, this was his first flight in this flap only, high performance glider. The glider was towed to 5,000 feet, where the pilot practiced pattern work as well as extending and retracting the flaps, from zero degrees to 90 degrees, while maintaining an adequate airspeed for landing. The pilot entered a tight traffic pattern at the airport and extended the flaps to 30 degrees. On the final leg of the traffic pattern, the glider was in line with the runway, and the pilot intended to extend the flaps to 45 degrees, but was unsure if he did so. When the glider was halfway down the runway, the pilot knew he had excessive airspeed and was going to land further down the runway than intended. Near the end of the runway, the pilot thought he landed so he pushed the controls forward in order to gain ground control, but the glider continued over trees past the end of the runway. Since the glider did not have enough altitude to safely turn back to the runway, the pilot landed it in trees resulting in substantial damage to the fuselage. The pilot stated that he accumulated 107 hours of total flight time in a glider, of which, no hours were in the same make and model as the accident glider. The pilot reported there were no preexisting mechanical anomalies with the glider.

Full narrative

According to the pilot, this was his first flight in this flap only, high performance glider. The glider was towed to 5,000 feet, where the pilot practiced pattern work as well as extending and retracting the flaps, from zero degrees to 90 degrees, while maintaining an adequate airspeed for landing. The pilot entered a tight traffic pattern at the airport and extended the flaps to 30 degrees. On the final leg of the traffic pattern, the glider was in line with the runway, and the pilot intended to extend the flaps to 45 degrees, but was unsure if he did so. When the glider was halfway down the runway, the pilot knew he had excessive airspeed and was going to land further down the runway than intended. Near the end of the runway, he pushed the controls forward in order to gain ground control, but the glider continued over trees past the end of the runway. Since the glider did not have enough altitude to safely turn back to the runway, the pilot landed in trees resulting in substantial damage to the fuselage. The pilot reported there were no preexisting mechanical anomalies with the glider and that he had never flown this make and model glider.

Probable cause

The pilot's misjudgment of the amount of flaps required to attain the proper touchdown point. Contributing to the accident was the pilot's limited experience in the high performance glider. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
240
Wind speed (kt)
6
Temperature (F)
88
Nearest airport
Sterling Airport
Distance from field
0.0
Airport elevation
459

Aircraft

RegistrationMakeModelDamageFAR part
N99136 — — SUBS 091

Sequence of events

#OccurrencePhase
1 Landing Landing area overshoot defining Cruise
2 Landing Collision during takeoff/land Cruise

Findings

Finding
Personnel issues-Action/decision-Action-Incorrect action performance-Pilot cause
Personnel issues-Experience/knowledge-Experience/qualifications-Total experience w/ equipment-Pilot - F cause
Aircraft-Aircraft systems-Flight control system-TE flap control system-Incorrect use/operation cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Landing flare-Not attained/maintained cause