N5175D accident
NTSB WPR11CA309 · 2011-07-05 · Vancouver, WA · near KVUO
Docket — crew, injuries and powerplant
Summary
The banner tow pilot reported that he approached the banner tow pickup point to catch the rope with his tail hook. Shortly after his initial pitch up maneuver to hook the rope, the pilot observed through a small mirror that the rope was not attached to his tail hook. Subsequently the banner lifted off the ground and the pilot could see that the banner rope looked like it was resting on or around his right horizontal stabilizer. Photos taken of the airplane in the air by a witness prior to the accident show the tow rope hooked around the nose gear and looped over the right horizontal stabilizer. Unable to release the banner, the pilot returned to land on the grassy area next to the runway as he was concerned that the banner might get snagged on obstacles located around the runway. As the pilot began his landing approach at approximately a 300 foot per minute descent and was crossing the west end of the runway, he brought the throttle to idle, added full flaps, and tried to maintain 60 mph. As the airplane descended the banner contacted the ground resulting in a significant amount of drag to the airplane. According to the pilot the airspeed began to drop and he attempted to maintain it by further lowering the nose. The airplane contacted the ground hard and the firewall sustained substantial damage. The pilot reported that there were no preimpact mechanical malfunctions or failures with the airframe and engine that would have precluded normal operation.
Full narrative
The banner tow pilot reported that he approached the banner tow pickup point to catch the rope with his tail hook. Shortly after his initial pitch up maneuver to hook the rope, the pilot observed through a small mirror that the rope was not attached to his tail hook. Subsequently the banner lifted off the ground and the pilot could see that the banner rope looked like it was resting on or around his right horizontal stabilizer. Photos taken of the airplane in the air by a witness prior to the accident show the tow rope hooked around the nose gear and looped over the right horizontal stabilizer. Unable to release the banner, the pilot returned to land on the grassy area next to the runway, due to a fear that the banner might get snagged on obstacles located around the runway. As the pilot began his landing approach at approximately a 300 foot per minute descent and was crossing the west end of the runway, he brought the throttle to idle, added full flaps, and tried to maintain 60 mph. As the airplane descended the banner contacted the ground resulting in a significant amount of drag to the airplane. According to the pilot the airspeed began to drop and he attempted to maintain it by further lowering the nose. The airplane then contacted the ground hard, substantially damaging the firewall of the airplane. The pilot reported that there were no preimpact mechanical malfunctions or failures with the airframe and engine that would have precluded normal flight.
Probable cause
The pilot's failure to properly engage the banner tow rope with the airplane's tail hook. The National Transportation Safety Board determined the probable cause of this accident.
Circumstances
- Event type
- Accident
- Highest injury
- Minor
- Weather conditions
- Visual Meteorological Cond
- Light condition
- Day
- Sky condition
- NONE
- Ceiling (ft)
- 0
- Visibility (sm)
- 10
- Wind direction
- 311
- Wind speed (kt)
- 7
- Temperature (F)
- 73
- Nearest airport
- Pearson Field
- Distance from field
- 0.0
- Airport elevation
- 25
Aircraft
| Registration | Make | Model | Damage | FAR part |
|---|---|---|---|---|
| N5175D | — | — | SUBS | 091 |
Sequence of events
| # | Occurrence | Phase |
|---|---|---|
| 1 | Maneuvering-low-alt flying Miscellaneous/other | Climb |
| 2 | Landing-flare/touchdown Hard landing defining | Cruise |
Findings
| Finding | |
|---|---|
| Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot | cause |
| Aircraft-Fluids/misc hardware-Misc hardware-(general)-Incorrect use/operation | cause |