N30456 Mcdonald Lynn B AVID FLYER MARK IV accident

NTSB WPR11CA358 · 2011-07-31 · Yamhill, OR · near OR05

Docket — crew, injuries and powerplant

Summary

The pilot reported that his approach to, and landing on, the private airstrip in his amateur-built, experimental, conventional gear airplane were normal. During rollout in the calm wind condition, the airplane began an uncommanded right turn. The pilot attempted to correct his loss of directional control by application of rudder and engine power. However, the tail wheel had unlocked and was evidently in a castoring mode. Despite his efforts to straighten the airplane’s path, the airplane veered off the runway and impacted a ditch. During the impact sequence one propeller blade broke, and the left wingtip and a wing rib were broken. The pilot reported that he built and maintained the experimental airplane. He opined that the accident could have been prevented had the angle of the tail wheel assembly been correct. After years of use, the tail wheel spring-to-empennage attachment assembly flattened. The incorrect angle altered the tail wheel’s pivot point. This event, combined with the vibration induced during rollout on the gravel runway, allowed the tail wheel to unlock.

Full narrative

The pilot reported that his approach to, and landing on, the private airstrip in his homebuilt, experimental, conventional gear airplane were normal. During rollout in the calm wind condition, the airplane began an uncommanded right turn. The pilot stated that he attempted to correct his loss of directional control by application of rudder and engine power. However, the tail wheel had unlocked and was evidently in a castoring mode. Despite his efforts to straighten the airplane’s path, the airplane veered off the runway. It rolled over brush and went into a ditch. During the impact sequence one propeller blade broke, and the left wingtip and a wing rib were broken. The pilot reported that he built and maintained the experimental airplane. He opined that the accident could have been prevented had the angle of the tail wheel assembly been correct. After years of use, the tail wheel spring-to-empennage attachment assembly flattened. The incorrect angle altered the tail wheel’s pivot point. This event, combined with the vibration induced during rollout on the gravel runway, allowed the tail wheel to unlock.

Probable cause

The pilot’s loss of directional control during landing rollout due to an unlocked tail wheel that was caused by a degradation of the tailwheel assembly mounting angle. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Temperature (F)
64
Nearest airport
Flying M
Distance from field
0.0
Airport elevation
448

Aircraft

RegistrationMakeModelDamageFAR part
N30456 MCDONALD LYNN B AVID FLYER MARK IV SUBS 091

Sequence of events

#OccurrencePhase
1 Landing-landing roll Sys/Comp malf/fail (non-power) defining Cruise
2 Landing-landing roll Loss of control on ground Cruise
3 Landing-landing roll Runway excursion Cruise
4 Landing-landing roll Collision with terr/obj (non-CFIT) Cruise

Findings

Finding
Aircraft-Aircraft systems-Landing gear system-Nose/tail landing gear-Damaged/degraded cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Directional control-Not attained/maintained cause
Environmental issues-Physical environment-Runway/land/takeoff/taxi surfa-(general)-Contributed to outcome factor