N8152Z accident

NTSB ANC11CA075 · 2011-08-12 · Kodiak, AK · near PADQ

Docket — crew, injuries and powerplant

Summary

The pilot and the operator's director of maintenance (DOM) were on a postmaintenance check flight. According to the pilot, while approaching to land, the throttle control became inoperative, resulting in a partial loss of engine power. The pilot selected a tidal beach as a forced landing site but was unable to reach it and landed in shallow water short of the site. The airplane sustained substantial damage to the wings and fuselage. The DOM reported that, while troubleshooting a recurring complaint of low engine manifold pressure, he noticed that the castellated nut, which connects the throttle linkage to the fuel control servo, was loose. He said that he removed the cotter pin, tightened the nut, and reinstalled the cotter pin. A postaccident engine examination revealed that a self-locking nut was missing from the throttle linkage arm, resulting in the disconnection of the throttle cable. The DOM said that the missing locknut was not the same one that he tightened but was a nut on the other end of the throttle linkage arm, about 2 inches from the castellated nut that he tightened. The DOM noted that he should have checked the security of the self-locking nut, but he did not. The self-locking nut was not recovered.

Full narrative

The pilot and the operator's director of maintenance (DOM), were on a postmaintenance check flight. According to the pilot's written statement, while approaching to land, the throttle control became inoperative, resulting in a partial loss of engine power. The pilot selected a tidal beach as a forced landing site, but was unable to reach it, and landed in shallow water short of the site. The airplane sustained substantial damage to the wings and fuselage. In a written statement to the NTSB, the DOM reported that while troubleshooting a recurring complaint of low engine manifold pressure, he noticed that the castellated nut, which connects the throttle linkage to the fuel control servo, was loose. He said he removed the cotter pin, tightened the nut, and reinstalled the cotter pin. A postaccident engine examination revealed that a self-locking nut was missing from the throttle linkage arm, resulting in the disconnection of the throttle cable. The DOM said that the missing locknut was not the same one that he removed, tightened and reinstalled, but was a nut on the other end of the throttle linkage arm, about 2 inches from the castellated nut that he tightened. The DOM noted that he should have checked the security of the hexagon self-locking nut, but he did not. The hexagon self-locking nut was not recovered.

Probable cause

A partial loss of engine power while on approach to land due to a disconnected throttle control linkage, and the maintenance director's inadequate inspection of the throttle linkage during maintenance. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
280
Wind speed (kt)
11
Temperature (F)
64
Nearest airport
Kodiak
Distance from field
0.0
Airport elevation
78

Aircraft

RegistrationMakeModelDamageFAR part
N8152Z — — SUBS 091

Sequence of events

#OccurrencePhase
1 Approach-VFR pattern final Loss of engine power (partial) defining Cruise
2 Landing-flare/touchdown Off-field or emergency landing Cruise

Findings

Finding
Aircraft-Aircraft power plant-Engine fuel and control-Fuel control/carburetor-Inadequate inspection cause
Personnel issues-Task performance-Maintenance-Repair-Maintenance personnel cause