N83533 accident

NTSB CEN11LA614 · 2011-09-01 · Valparaiso, IN · near VPZ

Docket — crew, injuries and powerplant

Summary

During landing, the airplane exited the right side of the runway and struck a ditch, and the main landing gear collapsed. No defects were found with the airplane's brake system. Photographic evidence of skid marks showed that the tailwheel experienced shimmy during the landing, which continued to the side of the runway. Postaccident examination of the airplane revealed some play in the tailwheel assembly due to wear, which allowed the tailwheel to shimmy during the landing.

Full narrative

On September 1, 2011, about 0815 central daylight time, an Aeronca 7AC, N83533, was damaged when it departed the right side of runway 9 and struck an adjacent ditch while landing at the Porter County Regional Airport (VPZ), Valparaiso, Indiana. The pilot and passenger were not injured. The airplane sustained substantial damage to the fuselage longerons. The aircraft was registered to Skyview Aviation LLC, and operated by the pilot under the provisions of 14 Code of Federal Regulations Part 91 as a personal flight. Visual meteorological conditions prevailed for the flight, which was not operated on a flight plan. The flight originated from the Greenville Municipal Airport (6D6), Greenville, Michigan about 0600.

The pilot reported that she made a wheel landing in the tail wheel equipped airplane holding the tail up until the tail wheel settled onto the runway. She said that once the tail wheel contacted the runway the airplane turned to the right which she countered by applying left rudder. The airplane continued to turn to the right. The pilot reported that she applied left brake which had no effect. The pilot reported that at this point, the airplane was in the grass adjacent to the runway and was approaching a hill/ditch. She applied both brakes, but only the right brake was effective which caused the airplane to turn more to the right. The airplane went over the hill/ditch and the landing gear collapsed.

The pilot reported that there was excessive play found in the tail wheel assembly, and that the left brake was not functional.

Examination of the airplane by a Federal Aviation Administration Inspectors after the accident revealed no anomalies with regard to the left brake system of the airplane. Some wear of the tailwheel assembly was noted, but the tail wheel was operational and appeared to be in an airworthy condition.

Photographs of the runway after the accident showed skid mark evidence that the airplane's tail wheel experienced shimmy during the landing. The shimmy continued to the side of the runway.

Probable cause

The pilot’s loss of directional control during landing. Contributing to the accident was the wear in the tailwheel assembly. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
20
Wind direction
0
Temperature (F)
72
Nearest airport
Porter County Regional Airport
Distance from field
0.0
Airport elevation
770

Aircraft

RegistrationMakeModelDamageFAR part
N83533 — — SUBS 091

Sequence of events

#OccurrencePhase
1 Landing-landing roll Loss of control on ground defining Cruise
2 Landing-landing roll Runway excursion Cruise
3 Landing-landing roll Collision with terr/obj (non-CFIT) Cruise

Findings

Finding
Aircraft-Aircraft systems-Landing gear system-Nose/tail landing gear-Not specified - F cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Directional control-Not attained/maintained cause
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause