N85AY Brumbaugh B/Kasowski L AVID FLYER IV accident

NTSB CEN12CA329 · 2012-05-29 · Pryor, OK · near H71

Docket — crew, injuries and powerplant

Summary

The pilot was performing a high speed taxi before an intended local flight. During the high speed taxi, the airplane's tail rose off the ground, and the pilot reduced power. During the subsequent rollout, the tailwheel started to shimmy, and the pilot applied left and right rudder. The airplane veered left, exited the runway, went down a steep slope, and impacted the side of a drainage ditch, which resulted in substantial damage to the wings and fuselage. The pilot reported no mechanical malfunctions.

Full narrative

The pilot was performing a high speed taxi prior to an intended local flight. During the high speed taxi, the airplane's tail rose off the ground and the pilot reduced power. During the subsequent rollout, the tailwheel started to shimmy and the pilot applied left and right rudder. The airplane veered left and exited the runway, went down a steep slope and impacted the side of a drainage ditch, where it sustained substantial damage to its wings and fuselage. The pilot reported no mechanical malfunctions.

Probable cause

The pilot's failure to maintain directional control during a high speed taxi. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Temperature (F)
79
Nearest airport
Mid-America Industrial Airport
Distance from field
0.0
Airport elevation
622

Aircraft

RegistrationMakeModelDamageFAR part
N85AY BRUMBAUGH B/KASOWSKI L AVID FLYER IV SUBS 091

Sequence of events

#OccurrencePhase
1 Taxi Loss of control on ground defining Taxi
2 Taxi Collision with terr/obj (non-CFIT) Taxi

Findings

Finding
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Directional control-Not attained/maintained cause