N106TV accident

NTSB WPR12CA236 · 2012-05-30 · Burbank, WA

Docket — crew, injuries and powerplant

Summary

During an aerial application flight, the single engine helicopter was flying low over an apple orchard when the engine began to lose power. The pilot decreased his airspeed toward zero and performed a hovering autorotation into the orchard. During the landing, the rotor blades impacted the trees, and the tail boom separated from the main fuselage. An examination of the engine revealed that the compressor discharge pressure (PC) air tube, which connected the PC air filter to the power turbine governor was disconnected. The “B” nut that connected the tube to the PC air filter was present on the tube but not threaded onto the PC air filter boss. The threads on both the PC air filter boss and the “B” nut did not exhibit any damage or abnormalities. Review of the maintenance records showed that, about 6 hours before the accident, the turbine assembly and bleed valve had been replaced. Removal and reinstallation of the PC air tube was conducted as part of the documented maintenance. It is likely that maintenance personnel did not properly torque the “B” nut when reinstalling the tube and the loose “B” nut backed off in-flight. According to the engine manufacturer's technical representative, disconnection of the PC air tube during engine operation would result in a loss of engine power.

Full narrative

The pilot stated that as he was flying low over the apple orchard and rolled out of a turn, the engine began to lose power, which was accompanied by the engine out horn and light. He decreased his airspeed towards zero, and performed a hovering autorotation into the orchard. During the landing the rotor blades impacted the trees and the tail boom separated from the main fuselage. An examination of the engine revealed that Pc air tube that connects the Pc air filter to to the Power Turbine Governor (PTG) was disconnected. The b-nut that connects the tube to the Pc air filter was present on the tube but not threaded onto the Pc air filter boss. Review of the maintenance records showed that about 6 hours prior to the accident the turbine assembly and bleed valve had been replaced. The threads on both the Pc air filter and b-nut did not exhibit any damage or abnormalities. The removal and reinstallation of the Pc air tube was conducted as part of the documented maintenance. According to the engine manufacturer's technical representative, the disconnection of the Pc air tube during engine operation would result in a loss of engine power.

Probable cause

The failure of maintenance personnel to properly torque an air tube fitting, which resulted in a total loss of engine power. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
140
Wind speed (kt)
4
Temperature (F)
57
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N106TV — — SUBS 137

Sequence of events

#OccurrencePhase
1 Maneuvering-low-alt flying Loss of engine power (total) defining Climb
2 Autorotation Collision with terr/obj (non-CFIT) Descent

Findings

Finding
Aircraft-Aircraft power plant-Engine fuel and control-Fuel controlling system-Malfunction cause
Personnel issues-Action/decision-Action-Forgotten action/omission-Maintenance personnel cause
Aircraft-Fluids/misc hardware-Misc hardware-Hoses and tubes-Incorrect service/maintenance cause