N73182 accident

NTSB CEN12LA408 · 2012-07-01 · Griswold, IA

Docket — crew, injuries and powerplant

Summary

The pilot and passenger departed from a 2,500-foot-long private airstrip; they then made two passes over the airstrip before returning to land the airplane. The pilot reported that his vision was affected by the setting sun, crop shadows, and a barn during the landing and that he landed long and fast. As the end of the airstrip approached, the pilot applied power for a go-around, but, according to the pilot, the engine did not produce power; the airplane became airborne, and the pilot turned left, but the airplane could not hold altitude. The airplane impacted a field just south of the airstrip. A witness reported that the engine maintained power throughout the accident sequence; additional witnesses reported that the airplane lost airspeed and stalled while in a turn. Examination of the propeller blades revealed signatures consistent with engine power being produced at the time of impact; examination of the airframe and engine did not reveal any preaccident malfunctions or failures that would have precluded normal operation. The accident is consistent with inadequate airspeed followed by an aerodynamic stall.

Full narrative

On June 30, 2012, about 2030 central daylight time, a Cessna 172 airplane, N73182, impacted a field shortly after departure from a private airfield near Griswold, Iowa. The private rated pilot and passenger received serious injuries and the airplane sustained substantial damage. The airplane was registered to and operated by a private individual. Day visual meteorological conditions prevailed and no flight plan was filed for the 14 Code of Federal Regulations Part 91 flight.

The pilot departed from a 2,500 foot airstrip, with several other airplanes to perform a water balloon drop. The airplane made two passes over the airstrip for the balloon drop before returning to land. The pilot reported that during the landing, the setting sun, shadows from the crops, and the barn affected his vision, and he landed long and fast. As the end of the airstrip approached, he applied power for a go-around. The pilot added that the engine did not produce power; the airplane went airborne, he turned left, but could not hold altitude. The airplane impacted a field just south of the airstrip. Witnesses reported that the airplane pulled up and then stalled, or got slow and then stalled in the turn.

A Federal Aviation Administration inspector and a technical representative from the airframe manufacturer responded to the accident site. The airplane’s control continuity and the presence of fuel were confirmed on-site. The FAA inspector added that a witness reported that the engine maintained power throughout the accident sequence. An examination of the engine by the inspector and technical representative did not reveal any preimpact abnormalities. The inspector added that both blades of the fixed pitch propeller had leading edge polishing with one blade twisted back, towards the airframe. During the crash, the airplane sustained heavy impact damage including nearly severing the fuselage just aft of the cabin area.

Probable cause

The pilot’s failure to maintain adequate airspeed during an attempted go-around, resulting in an aerodynamic stall. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Serious
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Temperature (F)
82
Nearest airport
Private
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N73182 — — SUBS 091

Sequence of events

#OccurrencePhase
1 Landing Abnormal runway contact Cruise
2 Landing-aborted after touchdown Attempted remediation/recovery Cruise
3 Takeoff Aerodynamic stall/spin defining Takeoff

Findings

Finding
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Airspeed-Not attained/maintained cause