N7779H accident

NTSB ANC12CA072 · 2012-07-06 · Quinhagak, AK

Docket — crew, injuries and powerplant

Summary

The pilot stated that he was landing his tailwheel-equipped airplane at an off-airport site. During the landing roll, he aborted the landing but was unable to clear terrain at the departure end of the site, about 400 feet from where he aborted the landing. The airplane impacted the ground, sustaining substantial damage to both wings and the fuselage. The pilot indicated that there were no preaccident mechanical anomalies with the airplane that would have precluded normal operation. In his written statement to the NTSB, the pilot stated that the engine may not have been producing full power but, if so, he did not realize it or take any corrective action, such as applying carburetor heat. In a telephone conversation, he said that he had been flying at reduced power settings during his reconnaissance passes, with occasional use of carburetor heat to clear any possible carburetor ice. He also stated that his normal before-landing procedure is to turn off the carburetor heat on short final. According to a carburetor icing probability chart, an airplane operating in the ambient conditions at the accident site, as reported by the pilot, could expect a serious risk of carburetor icing while at cruise power.

Full narrative

In a telephone conversation with the National Transportations Safety Board (NTSB) investigator-in-charge just after the accident, the pilot stated that he was landing his tailwheel-equipped airplane at an off-airport site. During the landing roll he aborted the landing, but he was unable to clear terrain at the departure end of the site, about 400 feet from where he aborted the landing. The airplane impacted terrain, sustaining substantial damage to both wings, and the fuselage. The pilot indicated that there were no preaccident mechanical anomalies with the airplane that would have precluded normal operation.

In his written statement to the NTSB, the pilot stated that the engine may not have been producing full power, but he did not realize it, or take any corrective action for application of carburetor heat.

In a telephone conversation on August 23, he said had been flying at reduced power settings during his reconnaissance passes, with occasional use of carburetor heat to clear any possible carburetor ice. He also stated that his normal before-landing procedure is to turn off the carburetor heat on short final.

According to a carburetor icing probability chart, an airplane operating in the ambient conditions at the accident site, reported by the pilot, could expect serious carburetor icing while at cruise power.

Probable cause

The pilot's failure to use continuous carburetor heat while operating in conditions conducive to carburetor icing, which resulted in the development of carburetor ice and a subsequent partial loss of engine power. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
BKN
Ceiling (ft)
1200
Visibility (sm)
10
Wind direction
350
Temperature (F)
45
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N7779H — — SUBS 091

Sequence of events

#OccurrencePhase
1 Landing-aborted after touchdown Miscellaneous/other Cruise
2 Initial climb Loss of engine power (partial) defining Takeoff
3 Initial climb Collision with terr/obj (non-CFIT) Takeoff

Findings

Finding
Personnel issues-Task performance-Use of equip/info-Use of equip/system-Pilot cause
Environmental issues-Conditions/weather/phenomena-Temp/humidity/pressure-Conducive to carburetor icing-Decision related to condition cause