N218LG accident

NTSB ERA12IA559 · 2012-09-10 · Opa-Locka, FL · near OPF

Docket — crew, injuries and powerplant

Summary

The airline transport pilot had landed the airplane after conducting a personal flight. He stated that, while turning left off of the active runway after landing, the airplane "began veering to the left" and that the right main landing gear (MLG) subsequently collapsed. Examination of the right MLG revealed that it had failed. Examination of the landing gear bellcrank revealed that one of the clevis knuckles on the long bellcrank arm was fractured. The fracture surface had a rough appearance and was at an angle to the longitudinal axis of the clevis arm, consistent with an overstress fracture. No other anomalies were noted with the landing gear.

Full narrative

On September 10, 2012, about 1650 eastern daylight time, a Cessna 402B, N218LG, landed at Opa-Locka Executive Airport (OPF), Miami, Florida, and after clearing the runway, the right main landing gear collapsed. The airline transport-rated pilot and two passengers were not injured. The airplane sustained minor damage. The airplane was registered to and operated by Waymen Aviation Services Inc. under the provisions of 14 Code of Federal Regulations Part 91 as a personal flight. Visual meteorological conditions prevailed and no flight plan was filed. The flight originated from OPF at 1600.

The pilot stated that, while turning left off of the active runway after landing, the airplane "began veering to the left," and the right main landing gear subsequently collapsed. The right main landing gear was examined by a Federal Aviation Administration inspector, and he confirmed the damage to the right main landing gear assembly.

The landing gear bellcrank was sent to the NTSB materials laboratory for examination. The bellcrank consisted of a long arm, approximately 7.5 inches long, and a short arm, approximately 2.1 inches long, with a 105-degree included angle between the two. The end of each arm was shaped in the form of a clevis. One of the clevis knuckles on the long bellcrank arm was fractured. The fracture surface had a rough appearance and was at an angle to the longitudinal axis of the clevis arm, consistent with an overstress fracture. No other anomalies were noted with the landing gear.

Probable cause

The pilot’s turning the airplane too sharply while exiting the runway, which resulted in the failure of the right main landing gear bellcrank due to an overstress fracture. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Incident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
300
Wind speed (kt)
10
Temperature (F)
90
Nearest airport
Opa-Locka Executive Airport
Distance from field
0.0
Airport elevation
8

Aircraft

RegistrationMakeModelDamageFAR part
N218LG — — MINR 091

Sequence of events

#OccurrencePhase
1 Taxi-from runway Abrupt maneuver Taxi
2 Taxi-from runway Landing gear collapse defining Taxi

Findings

Finding
Aircraft-Aircraft systems-Landing gear system-Main gear strut/axle/truck-Capability exceeded cause
Aircraft-Aircraft systems-Landing gear system-Main gear strut/axle/truck-Failure cause
Personnel issues-Task performance-Use of equip/info-Use of equip/system-Pilot cause