N127AR accident

NTSB ERA12CA581 · 2012-09-26 · Statesboro, GA · near TBR

Docket — crew, injuries and powerplant

Summary

According to the flight instructor, the purpose of the flight was to complete recurrent training in the airplane. While on the downwind leg for a landing on runway 5, the flight instructor configured the airplane for a simulated engine failure maneuver. The pilot said he told the instructor that the airplane was too high for a landing on runway 5, so they agreed that he would land on runway 32.The pilot said that as he turned the airplane onto the final leg for runway 32, the airplane overshot the centerline and it began to descend about 200 feet per minute. About 150 feet above ground level, the pilot added power, but the airplane continued to descend and the left main gear and left wing tip impacted the runway and the airplane bounced. The pilot added full power and executed a go-around. The pilot said that during the go-around he noticed that the left outboard wing was bent and an observer in the back of the airplane reported that the left main landing gear was bent. The pilot said he flew the airplane around the pattern, and after the airplane landed, he noted it was difficult to steer the airplane and the airplane veered off the runway and came to rest in a grassy area. During the hard landing, the airplane sustained substantial damage to the left wing. The flight instructor reported no preimpact mechanical malfunctions or failures with the airplane that would have precluded normal operation.

Full narrative

According to the flight instructor, the purpose of the flight was to complete recurrent training in the airplane. While on the downwind leg of the traffic pattern, the flight instructor configured the airplane for a simulated engine failure maneuver. The airplane was about a quarter mile from the runway on the base leg of the traffic pattern and the ground proximity warning system announced “500 feet.” As the pilot turned the airplane onto the final leg of the traffic pattern, the airplane overshot the centerline and it began to descend about 200 feet per minute. Then, about 150 feet above ground level, the pilot began to add power, but the airplane continued to descend and subsequently impacted the runway and bounced. The pilot recovered the airplane from the bounce, proceeded to takeoff and flew the airplane around the pattern. The occupants of the airplane noted that the left wing was bent and witness told them that the left main landing gear was bent. During the landing, the airplane veered off the runway and came to rest in a grassy area. During the accident sequence, the airplane incurred substantial damage to the left wing. The flight instructor reported no preimpact mechanical malfunctions or failures with the airplane that would have precluded normal operation.

Probable cause

The pilot’s inadequate flare, which resulted in a hard landing. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
50
Wind speed (kt)
4
Temperature (F)
75
Nearest airport
Statesboro-Bulloch County
Distance from field
0.0
Airport elevation
187

Aircraft

RegistrationMakeModelDamageFAR part
N127AR — — SUBS 091

Sequence of events

#OccurrencePhase
1 Landing Hard landing defining Cruise
2 Landing Abnormal runway contact Cruise

Findings

Finding
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Landing flare-Not attained/maintained cause
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause