N21301 accident

NTSB CEN13CA224 · 2013-03-23 · Grand Rapids, MN

Docket — crew, injuries and powerplant

Summary

The flight instructor hand-propped the engine and the student pilot set the engine controls before the flight. The flight consisted mainly of practicing ground reference maneuvers and slips. The flight instructor reported that they were about 700 feet above the ground when the engine lost all power and the propeller stopped spinning. The flight instructor performed the emergency checklist by memory and located a frozen lake on which to land. The airplane nosed over during the landing roll, which resulted in substantial damage to the wing spars. Photos taken at the accident site showed that the fuel primer control was unlocked and the primer control was at an intermediate position. The flight instructor reported that the student stated he locked the primer control, but only turned the control about 1/8 inch to lock it. The flight instructor stated that the primer control was in its locked position when he checked it before the flight. It could not be determined how the primer control became unlocked. The engine was started and ran normally during the postaccident examination. When the primer control was placed in the position found after the accident and the power was reduced to 1,000 rpm, the engine lost all power. The airplane was not equipped with an electrical system and therefore could not be restarted in flight.

Full narrative

The certified flight instructor (CFI) hand propped the engine and the student set the engine controls prior to the flight. The flight consisted mainly of practicing ground reference maneuvers and slips. The CFI reported that they were at an altitude of about 700 feet above the ground when the engine lost all power and the propeller stopped spinning. The CFI performed the emergency checklist, by memory, and located a frozen lake on which to land. The airplane nosed over after traveling about 30 feet during the landing roll which resulted in substantial damage to wooded wing spars. Photos taken at the accident site show the fuel primer control was unlocked and the primer control was at an intermediate position. The CFI reported the student stated he locked the primer control, but only turned the control about an eighth of an inch to lock it. The CFI stated primer control was in when he had checked it prior to the flight. It could not be determined how the primer control became unlocked. The engine was started and it ran normally during the postaccident examination. When the primer control was placed in the position found after the accident and the power was reduced to 1,000 rpm, the engine lost all power. The airplane was not equipped with an electrical system and therefore could not be restarted in flight.

Probable cause

The student pilot’s failure to adequately lock the primer before takeoff and the flight instructor's failure to verify that the primer was adequately locked. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
BKN
Ceiling (ft)
4100
Visibility (sm)
10
Wind direction
350
Wind speed (kt)
3
Temperature (F)
32
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N21301 — — SUBS 091

Sequence of events

#OccurrencePhase
1 Enroute-descent Fuel starvation Climb
2 Maneuvering-low-alt flying Loss of engine power (total) defining Climb
3 Landing-landing roll Nose over/nose down Cruise

Findings

Finding
Aircraft-Aircraft systems-Fuel system-Fuel distribution-Incorrect use/operation cause
Personnel issues-Task performance-Use of equip/info-Use of equip/system-Student pilot cause
Personnel issues-Psychological-Attention/monitoring-(general)-Instructor/check pilot cause