N7924S Bell 47G-3B-1 accident

NTSB CEN13LA395 · 2013-07-06 · Plover, WI

Docket — crew, injuries and powerplant

Summary

The pilot reported that the engine was at 3,200 rpm (full power) during takeoff. He completed the last aerial application pass, initiated a climb, and made a 180-degree turn. During the course reversal, the engine power was about 2,000 rpm. He was increasing the power during the rollout when the helicopter descended rapidly and impacted the field. A postaccident examination of the airframe and engine revealed no evidence of mechanical malfunctions or failures that would have precluded normal operation.

Full narrative

On July 6, 2013, about 1110 central daylight time, a Bell 47G-3B-1 helicopter, N7924S, sustained substantial during an agricultural aerial application flight near Plover, Wisconsin. The pilot was performing a 180-degree course reversal when the helicopter impacted the terrain. The pilot, the sole occupant, received minor injuries. The helicopter was registered to 102 Leasing LLC and operated by Reabe Spraying Service under the provisions of the 14 Code of Federal Regulations Part 137 as an aerial application flight. Visual meteorological conditions prevailed at the time of the accident, and no flight plan was filed. The flight originated from a private airstrip near Plover, Wisconsin, about 1105.

The pilot reported that he was finishing the field after having flown about 5 hours of aerial application flights for the day. On the accident flight, the helicopter was fueled with about 1/2 tank of fuel and about 4 gallons of pesticide. He completed the last pass along the west side of the field traveling to the north. He turned to the southeast and completed spraying a short segment of the field. He pulled up and did a 180-degree turn to the right. During the turn, the engine and rotor rpm were about 2,000 rpm when he started to reapply power. He rolled out of the turn and the helicopter impacted the field.

During an interview with a Federal Aviation Administration (FAA) inspector, the pilot reported that the engine was at 3,200 rpm (full power) during takeoff. During the course reversal turn, the engine was about 2,000 rpm, and he was reapplying power back to 3,200 rpm during the rollout when the helicopter impacted the field.

FAA inspectors examined the helicopter and determined that the collective, cyclic, and anti-torque pedals exhibited flight control continuity. The examination of the engine's fuel system and ignition system revealed no anomalies. The compression test revealed that all six cylinders had normal compression readings. The main rotor tachometer and engine tachometer were checked and were found operational. A teardown of the engine was conducted and no anomalies were noted which would have prevented normal operation.

Probable cause

The pilot’s failure to maintain proper engine rpm, which resulted in a high rate of descent and ground impact. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
190
Wind speed (kt)
8
Temperature (F)
81
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N7924S BELL 47G-3B-1 SUBS 137

Sequence of events

#OccurrencePhase
1 Maneuvering-low-alt flying Low altitude operation/event defining Climb
2 Maneuvering-low-alt flying Collision with terr/obj (non-CFIT) Climb

Findings

Finding
Personnel issues-Action/decision-Action-Incorrect action performance-Pilot cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Prop/rotor parameters-Not attained/maintained cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Descent rate-Not attained/maintained cause