N926BW accident

NTSB WPR13CA362 · 2013-08-01 · West Yellowstone, MT · near KWYS

Docket — crew, injuries and powerplant

Summary

The pilot and the pilot-rated passenger planned to conduct a personal flight in the tailwheel-equipped airplane. The pilot was in the rear seat, and the passenger was in the front seat. The passenger did not have a tailwheel endorsement, but he planned to follow the pilot on the controls during the takeoff for familiarization purposes. During the takeoff roll when the airplane was approaching liftoff speed, the airplane made a rapid veeroff to the left. At that point, the pilot abandoned the takeoff, and made the conscious decision not to attempt to return to the runway, instead allowing the airplane to roll and decelerate on the grass/gravel beside the runway. That decision was based on the pilot's desire to avoid any potentially hazardous maneuvering or a ground loop. During the rollout, due to the pilot's inability to see directly ahead, the airplane struck the VASI (visual approach slope indicator) installation located about 1,300 feet down the runway, and offset about 145 feet from the runway centerline. The airplane sustained substantial damage to the left wing struts. The pilot stated that he did not believe that any mechanical malfunction or failure contributed to or caused the runway excursion, and that he could not rule out the possibility that he had inadvertently applied one wheel brake during the takeoff roll.

Full narrative

The pilot and the pilot-rated passenger planned to conduct a personal flight in the tailwheel-equipped airplane. The pilot was in the rear seat, and the passenger was in the front seat. The passenger did not have a tailwheel endorsement, but he planned to follow the pilot on the controls during the takeoff for familiarization purposes. During the takeoff roll when the airplane was approaching liftoff speed, the airplane made a rapid veeroff to the left. At that point, the pilot abandoned the takeoff, and made the conscious decision not to attempt to return to the runway, instead allowing the airplane to roll and decelerate on the grass/gravel beside the runway. That decision was based on the pilot's desire to avoid any potentially hazardous maneuvering or a ground loop. During the rollout, due to the pilot's inability to see directly ahead, the airplane struck the VASI (visual approach slope indicator) installation located about 1,300 feet down the runway, and offset about 145 feet from the runway centerline. The airplane sustained substantial damage to the left wing struts. The pilot stated that he did not believe that any mechanical malfunction or failure contributed to or caused the runway excursion, and that he could not rule out the possibility that he had inadvertently applied one wheel brake during the takeoff roll.

Probable cause

The pilot's failure to maintain directional control during the takeoff roll, which resulted in a runway excursion and a collision with an approach slope indicator system component. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
170
Wind speed (kt)
3
Temperature (F)
50
Nearest airport
West Yellowstone
Distance from field
0.0
Airport elevation
6649

Aircraft

RegistrationMakeModelDamageFAR part
N926BW — — SUBS 091

Sequence of events

#OccurrencePhase
1 Takeoff Loss of control on ground defining Takeoff
2 Takeoff-rejected takeoff Collision during takeoff/land Takeoff
3 Takeoff-rejected takeoff Collision with terr/obj (non-CFIT) Takeoff

Findings

Finding
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Directional control-Not attained/maintained cause
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause
Environmental issues-Physical environment-Object/animal/substance-Runway/taxi/approach light-Not specified factor