N6617R accident

NTSB ERA13CA369 · 2013-08-11 · Verona, NY

Docket — crew, injuries and powerplant

Summary

The pilot stated after takeoff while en route to the destination airport he elected to fly to a private airstrip (Bates Field) located in rolling farmland. He lined up onto base leg for landing to the northwest on the upslope grass runway, and turned onto final approach. With 40 degrees of flaps extended, he identified the intended touchdown point, flared, and then climbed to attain the intended touchdown point. He landed, “but too hard and bounced up…,” touched down on the runway, and drifted off the runway into 6 to 8 inch high grass. He added power to abort the landing but impacted a knoll at the top of a crest on a hill, then continued climbing. While safely airborne he assessed the condition of the airplane noting the pilot and co-pilot doors were ajar, but did not find any other damage. He flew over the private airstrip and did not observe any damage then elected to proceed to his destination airport, where he landed uneventfully. While taxiing after landing he noticed the left landing gear was out of position. He further stated there was no preimpact mechanical failure or malfunction that caused the hard landing. Inspection of the airplane by a Federal Aviation Administration inspector revealed damage and distortion to structural tubing in the cockpit, and wrinkles in the fabric adjacent to the left main landing gear.

Full narrative

The pilot stated after takeoff while en route to the destination airport he elected to fly to a private airstrip (Bates Field) located in rolling farmland. He lined up onto base leg for landing to the northwest on the upslope grass runway, and turned onto final approach. With 40 degrees of flaps extended he identified the intended touchdown point and flared but then climbed to attain the intended touchdown point. He landed, “but too hard and bounced up…” then touched down on the runway but drifted off the runway into 6 to 8 inch high grass. He added power to abort the landing but impacted a knoll at the top of a crest of a hill, then continued climbing. While safely airborne he assessed the condition of the airplane noting the pilot and co-pilot doors were ajar, but did not find any other damage. He flew over the private airstrip and did not observe any damage then elected to proceed to his destination airport, where he landed uneventfully. While taxiing after landing he noticed the left landing gear was out of position. He further stated there was no preimpact mechanical failure or malfunction that caused the hard landing.

Inspection of the airplane by a Federal Aviation Administration inspector revealed damage and distortion to structural tubing in the cockpit, and wrinkles in the fabric adjacent to the left main landing gear.

Probable cause

The pilot’s delay in applying power after a bounced landing, resulting in collision with terrain during a go-around. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
BKN
Ceiling (ft)
4500
Visibility (sm)
10
Wind direction
250
Wind speed (kt)
5
Temperature (F)
72
Nearest airport
Bates Field
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N6617R — — SUBS 091

Sequence of events

#OccurrencePhase
1 Landing-flare/touchdown Hard landing defining Cruise
2 Landing-flare/touchdown Attempted remediation/recovery Cruise
3 Landing-aborted after touchdown Collision with terr/obj (non-CFIT) Cruise

Findings

Finding
Personnel issues-Action/decision-Action-Delayed action-Pilot cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Climb rate-Not attained/maintained cause
Environmental issues-Physical environment-Terrain-Mountainous/hilly terrain-Contributed to outcome factor