N51683 Enstrom Helicopter Corp 280C accident

NTSB WPR14CA101 · 2014-01-21 · Showlow, AZ · near SOW

Docket — crew, injuries and powerplant

Summary

The pilot reported that just after takeoff he hovered the helicopter about two feet above the ground before starting a northwesterly takeoff run over an area of grass-covered, uneven terrain. The pilot noted that during the takeoff run, the main rotor RPM began to decay, so he added engine throttle to correct for the RPM decline. The helicopter subsequently descended and during touchdown, the left main landing gear skid collapsed. The helicopter rolled to the left, and the main rotor blades struck the ground. The helicopter sustained substantial damage to the main rotor drive system, tail boom, and fuselage. The pilot reported that the estimated gross weight of the helicopter at takeoff was 2,300 pounds, or approximately 50 pounds under the maximum gross weight of 2,350 pounds. The density altitude was calculated to be 7,015 feet mean sea level. The pilot reported no preaccident mechanical malfunctions or failures with the helicopter that would have precluded normal operation.

Full narrative

The pilot reported that just after takeoff he hovered the helicopter about two feet above the ground before starting a northwesterly takeoff run over an area of grass-covered, uneven terrain. The pilot noted that during the takeoff run, the main rotor RPM began to decay, so he added engine throttle to correct for the RPM decline. The helicopter subsequently descended and during touchdown, the left main landing gear skid collapsed. The helicopter rolled to the left, and the main rotor blades struck the ground. The helicopter sustained substantial damage to the main rotor drive system, tail boom, and fuselage.

The pilot reported that the estimated gross weight of the helicopter at takeoff was 2,300 pounds, or approximately 50 pounds under the maximum gross weight of 2,350 pounds. The density altitude was calculated to be 7,015 feet mean sea level.

The pilot reported no preaccident mechanical malfunctions or failures with the helicopter that would have precluded normal operation.

Probable cause

The pilot's failure to maintain main rotor RPM during the takeoff run in a high density altitude environment, which resulted in a loss of aircraft control and collision with terrain. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
10
Wind speed (kt)
6
Temperature (F)
52
Nearest airport
SHOW LOW RGNL
Distance from field
0.0
Airport elevation
6415

Aircraft

RegistrationMakeModelDamageFAR part
N51683 ENSTROM HELICOPTER CORP 280C SUBS 091

Sequence of events

#OccurrencePhase
1 Takeoff Loss of control in flight defining Takeoff
2 Takeoff Loss of lift Takeoff

Findings

Finding
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Prop/rotor parameters-Not attained/maintained cause
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause
Environmental issues-Physical environment-Terrain-Sloped/uneven-Contributed to outcome factor
Environmental issues-Conditions/weather/phenomena-Temp/humidity/pressure-High density altitude-Effect on operation factor