N9083M accident

NTSB ANC14LA054 · 2014-07-14 · Seward, AK

Docket — crew, injuries and powerplant

Summary

The private pilot was landing his tailwheel-equipped airplane on a remote tidal beach. The pilot reported that, upon touchdown, the airplane bounced slightly before settling on the right main landing gear (MLG). In an effort to correct for the right-wing-low landing, the pilot applied left aileron, but the right wing continued to descend. The right MLG wheel axle separated from the gear leg, and the airplane slid along the beach, which resulted in substantial damage to the right wing and fuselage. Examination of the four right MLG attachment bolts revealed features consistent with an overload on the MLG axle. Therefore, it is likely the pilot executed a hard uncoordinated landing, which resulted in the separation of the right MLG axle upon landing.

Full narrative

On July 14, 2014, about 0930 Alaska daylight time, a Cessna 180H airplane, N9083M, sustained substantial damage while landing on a beach on Montague Island, about 60 miles east of Seward, Alaska. The airplane was being operated by the pilot as a visual flight rules (VFR) flight under the provisions of Title 14, CFR Part 91, when the accident occurred. The certificated private pilot, and the sole passenger were not injured. Visual meteorological conditions prevailed and a VFR flight plan had been filed. The flight departed Wolf Lake Airport, Palmer, Alaska at approximately 0835.

In a written report to the National Transportation Safety Board dated July 20, the pilot reported that he was landing on the beach at Patton Bay on the east side of Montague Island. Upon touchdown the airplane bounced slightly before settling on the right main landing gear. In an effort to correct for the right wing low landing the pilot applied left aileron, but the right wing continued to descend. The right main wheel separated from the gear leg, and the airplane slid along the surface sustaining substantial damage to the right wing and fuselage.

A postaccident examination, by the pilot, revealed that the right main landing gear axle separated from the gear leg. The axle and its four attaching bolts were sent to the NTSB's Materials Laboratory in Washington D.C. for examination.

A Senior Safety Board Materials Engineer reported that the two forward attachment bolts, were bent slightly aft and exhibited longitudinal wear marks near the end of the threaded section with helical strips of metal present near the middle of the threaded section. The two aft bolts were bent aft, and the fractured surfaces were consistent with an overstress fracture. A complete copy of the NTSB's materials laboratory factual report is included in the public docket for this accident.

Probable cause

The pilot’s execution of a hard uncoordinated landing, which resulted in the overstress fracture of the right main landing gear (MLG) axle attachment bolts and the subsequent separation of the of the right MLG axle. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
170
Wind speed (kt)
4
Temperature (F)
55
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N9083M — — SUBS 091

Sequence of events

#OccurrencePhase
1 Landing-flare/touchdown Abnormal runway contact Cruise
2 Landing-landing roll Landing gear collapse defining Cruise
3 Landing-landing roll Collision with terr/obj (non-CFIT) Cruise

Findings

Finding
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause
Aircraft-Aircraft systems-Landing gear system-Main gear strut/axle/truck-Capability exceeded cause