N7571T accident

NTSB WPR14CA295 · 2014-07-18 · El Monte, CA · near KEMT

Docket — crew, injuries and powerplant

Summary

While performing practice instrument approaches, the certified flight instructor (CFI) and pilot under instruction noticed that the right main landing gear indicator light was not illuminated when the landing gear handle was down. A visual check by the CFI confirmed that the right main landing gear was not down and locked. The crew cycled the landing gear and attempted to pump the gear down using the emergency gear handle. Both procedures were unsuccessful in bringing the right main landing gear into a down and locked position. The flight crew landed the airplane on the runway with the left main down and the right main partially extended. The right horizontal stabilizer impacted the runway causing the airplane to veer right, off the runway, and substantially damaging the horizontal stabilizer. A post flight inspection by a airframe and powerplants mechanic determined that the landing gear actuator splined drive shaft had failed. Cessna Service Bulletin SEB11-02, issued in April 2011, recommended a one time inspection of the main landing gear steel pivot assembly. According to the mechanic, the airplane maintenance records do no show that the recommended inspection had been performed.

Full narrative

While performing practice instrument approaches, the certified flight instructor (CFI) and pilot under instruction noticed that the right main landing gear indicator light was not illuminated when the landing gear handle was down. A visual check by the CFI confirmed that the right main landing gear was not down and locked. The crew cycled the landing gear and attempted to pump the gear down using the emergency gear handle. Both procedures were unsuccessful in bringing the right main landing gear into a down and locked position. The flight crew landed the airplane on the runway with the left main down and the right main partially extended. The right horizontal stabilizer impacted the runway causing the airplane to veer right, off the runway, and substantially damaging the horizontal stabilizer.

A post flight inspection by a airframe and powerplants mechanic determined that the landing gear actuator splined drive shaft had failed. Cessna Service Bulletin SEB11-02, issued in April 2011, recommended a one time inspection of the main landing gear steel pivot assembly. According to the mechanic, the airplane maintenance records do no show that the recommended inspection had been performed.

Probable cause

The failure of the right main landing gear pivot assembly. Contributing to the accident was the owner's failure to perform an inspection of the assembly in accordance with the manufacturer's service bulletin. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
210
Wind speed (kt)
8
Temperature (F)
73
Nearest airport
San Gabriel Valley Airport
Distance from field
0.0
Airport elevation
296

Aircraft

RegistrationMakeModelDamageFAR part
N7571T — — SUBS 091

Sequence of events

#OccurrencePhase
1 Landing-flare/touchdown Abnormal runway contact defining Cruise

Findings

Finding
Aircraft-Aircraft systems-Landing gear system-Landing gear actuator-Failure cause
Aircraft-Aircraft handling/service-Maintenance/inspections-Unscheduled maint checks-Not inspected - F cause