N6035S Cessna Aircraft Co E162 accident

NTSB WPR14CA386 · 2014-09-21 · Bellingham, WA · near KBLI

Docket — crew, injuries and powerplant

Summary

The student pilot planned to conduct a solo cross-country flight to another towered airport. His preflight inspection, engine start and runup, takeoff, and flight of the special light-sport airplane were all uneventful. When he neared the destination airport, he was instructed to enter the traffic pattern on the downwind leg for runway 16. He was subsequently cleared for "closed traffic" pattern work, and instructed to follow another airplane. The pilot informed the air traffic controller that he intended to do a full stop landing, and shortly thereafter, was instructed to turn base leg. He selected full flaps (40 degrees) for landing after turning final. According to the pilot, the wind was from 180 degrees at 7 knots, and the airplane was "just a little" to the right of the centerline for part of the last segment of the final approach. The pilot flared for landing, and the airplane touched down on the main gear, but then "ballooned" back airborne. The airplane bounced again, and then on the third bounce, the nose landing gear failed. The airplane slid to a stop on the runway. The airplane sustained substantial damage to the fuselage structure. During the bounce sequence, the pilot only used the control wheel to attempt to control and stop the bounces; he did not vary the throttle setting. The pilot reported no preimpact mechanical malfunctions or failures with the airplane that would have precluded normal operation.

Full narrative

The student pilot planned to conduct a solo cross-country flight to another towered airport. His preflight inspection, engine start and runup, takeoff, and flight of the special light-sport airplane were all uneventful. When he neared the destination airport, he was instructed to enter the traffic pattern on the downwind leg for runway 16. He was subsequently cleared for "closed traffic" pattern work, and instructed to follow another airplane. The pilot informed the air traffic controller that he intended to do a full stop landing, and shortly thereafter, was instructed to turn base leg. He selected full flaps (40 degrees) for landing after turning final. According to the pilot, the wind was from 180 degrees at 7 knots, and the airplane was "just a little" to the right of the centerline for part of the last segment of the final approach. The pilot flared for landing, and the airplane touched down on the main gear, but then "ballooned" back airborne. The airplane bounced again, and then on the third bounce, the nose landing gear failed. The airplane slid to a stop on the runway. The airplane sustained substantial damage to the fuselage structure. During the bounce sequence, the pilot only used the control wheel to attempt to control and stop the bounces; he did not vary the throttle setting. The pilot reported no preimpact mechanical malfunctions or failures with the airplane that would have precluded normal operation.

Probable cause

The pilot's inadequate flare and failure to maintain aircraft control during landing. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
160
Wind speed (kt)
6
Temperature (F)
75
Nearest airport
Bellingham Intl
Distance from field
0.0
Airport elevation
170

Aircraft

RegistrationMakeModelDamageFAR part
N6035S CESSNA AIRCRAFT CO E162 SUBS 091

Sequence of events

#OccurrencePhase
1 Landing-flare/touchdown Abnormal runway contact defining Cruise
2 Landing-flare/touchdown Sys/Comp malf/fail (non-power) Cruise

Findings

Finding
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Landing flare-Not attained/maintained cause
Personnel issues-Task performance-Use of equip/info-Aircraft control-Student/instructed pilot cause