N485MP Paquin Michael A A accident

NTSB GAA15CA127 · 2015-06-20 · Concord, NH · near CON

Docket — crew, injuries and powerplant

Summary

The pilot of the amateur built gyrocopter reported that during taxi to the runway, he was distracted by his electronic altimeter when it entered a sleep mode. After resetting the altimeter, the pilot immediately entered the active runway and initiated the takeoff roll without disengaging the main rotor brake. Subsequently, at 25 miles per hour during the takeoff roll he reported an unusual vibration and a knocking sound. The pilot attempted to reduce speed, but the gyrocopter tipped forward and to the left, the main rotor impacted the ground, and the gyrocopter rolled over on its right side coming to a stop on the runway.   During an interview with the pilot, he explained that the rotor brake must be disengaged before takeoff. He also stated that this accident may have been prevented if the rotor brake was designed in a manner that required manual hand pressure from the pilot.   The pilot stated there were no mechanical malfunctions or failures with the gyrocopter that would have precluded normal operation. Substantial damage was found along the main rotor and vertical stabilizer. 

Full narrative

The pilot of the amateur built gyrocopter reported that during taxi to the runway, he was distracted by his electronic altimeter when it entered a sleep mode. After resetting the altimeter, the pilot immediately entered the active runway and initiated the takeoff roll without disengaging the main rotor brake. Subsequently, at 25 miles per hour during the takeoff roll he reported an unusual vibration and a knocking sound. The pilot attempted to reduce speed, but the gyrocopter tipped forward and to the left, the main rotor impacted the ground, and the gyrocopter rolled over on its right side coming to a stop on the runway.

During an interview with the pilot, he explained that the rotor brake must be disengaged before takeoff. He also stated that this accident may have been prevented if the rotor brake was designed in a manner that required manual hand pressure from the pilot.

The pilot stated there were no mechanical malfunctions or failures with the gyrocopter that would have precluded normal operation. Substantial damage was found along the main rotor and vertical stabilizer.

Probable cause

The pilot's inability to maintain directional control during takeoff, which resulted in a roll over. Contributing to the loss of control was the pilot's failure to disengage the main rotor brake prior to takeoff. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Wind speed (kt)
5
Temperature (F)
73
Nearest airport
CONCORD MUNI
Distance from field
0.0
Airport elevation
342

Aircraft

RegistrationMakeModelDamageFAR part
N485MP PAQUIN MICHAEL A A SUBS 091

Sequence of events

#OccurrencePhase
1 Takeoff Miscellaneous/other Takeoff
2 Takeoff Loss of control on ground defining Takeoff
3 Takeoff Roll over Takeoff

Findings

Finding
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Directional control-Attain/maintain not possible cause
Personnel issues-Action/decision-Action-Forgotten action/omission-Pilot - F cause
Aircraft-Aircraft propeller/rotor-Main rotor drive-Main rotor brake-Incorrect use/operation factor