N4751S accident

NTSB CEN15LA284 · 2015-06-27 · Casper, WY · near KCPR

Docket — crew, injuries and powerplant

Summary

The private pilot was conducting a cross-country personal flight. Immediately after takeoff, the engine lost power. The pilot and pilot-rated passenger attempted to restore engine power but were unsuccessful. The airplane was unable to return to the airport, and the pilot conducted a forced landing, during which the airplane impacted terrain beyond the airport perimeter fence. An examination of the engine revealed that the sheath for the carburetor heat cable was separated from the clamp. A black rubber adhesive was found at the joint between the sheath and the clamp, but it was not securing the clamp to the joint. The carburetor heat at the carburetor was partially on, and the position could not be changed when actuated by the control knob in the cabin. An examination of the airframe, engine, and related systems revealed no further anomalies. The weather conditions at the time of the accident were conducive to the accumulation of serious carburetor icing at glide power; however, it could not be determined whether carburetor icing played a role in the loss of engine power. Even if carburetor icing had not accumulated, the separation of the sheath from the clamp would have prevented the proper operation of the carburetor heat, and the partial carburetor heat would have resulted in the loss of engine power at takeoff.

Full narrative

On June 27, 2015, about 0800 mountain daylight time, a Cessna TR182, N4751S, was substantially damaged when it impacted terrain west of the Natrona County International Airport (KCPR), Casper, Wyoming. Visual meteorological conditions prevailed at the time of the accident. The flight was conducted under the provisions of 14 Code of Federal Regulations Part 91 without a flight plan. The private pilot, pilot-rated passenger, and one additional passenger were seriously injured. The flight had just departed and was en route to Jackson Hole Airport, (KJAC), Jackson, Wyoming.The airplane was cleared for takeoff from runway 26. About 300 feet above ground level the engine began to run rough and lose power. The pilot and pilot-rated passenger attempted to restore engine power but were unsuccessful. The pilot-rated passenger "took control" of the airplane and attempted to return to the airport. The engine continued to run rough and lose power, and they were unable to return to a runway to land. The airplane impacted terrain beyond the airport perimeter fence, just off of the departure end of runway 26.

The left wing was bent and buckled, the fuselage was crushed up and aft, and the firewall was buckled. A postaccident examination of the engine revealed that the sheath for the carburetor heat cable was partially separated. A black rubber adhesive was at the joint between the sheath and the clamp joint but was not securing the clamp to the joint. The carburetor heat at the carburetor was partially on and the position could not be changed when actuated by the control knob inside the cabin of the airplane.

A blue liquid, consistent in smell with 100 low lead aviation fuel, was drained from the engine sump and left wing. The samples were clear of visible water or particle contamination. A quarter cup of a clear liquid was drained from the right wing. No other fuel or liquid was recovered from the right wing. The fuel samples were sent to a laboratory for further examination. The analysis of the chemical composition of the fuel samples was consistent with previously measured aviation gasolines.

An examination of the airframe, engine, and related systems revealed no further anomalies.

Temperature at the time of the accident was 18 degrees Celsius (C) (64 degrees Fahrenheit (F)) and a dewpoint of 10 degrees C (50 degrees F). A review of the carburetor icing probability chart, located in the Federal Aviation Administration's Special Airworthiness Information Bulletin CE-09-35, revealed that conditions at the time of the accident were conducive to the accumulation of serious carburetor icing at glide power.

Probable cause

The improper repair of the carburetor heat cable sheath to clamp joint, which prevented the proper operation of the carburetor heat and resulted in the loss of engine power. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Serious
Weather conditions
Visual Meteorological Cond
Light condition
Day
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Temperature (F)
64
Nearest airport
Natrona County Intl Airport
Distance from field
1.0
Airport elevation
5344

Aircraft

RegistrationMakeModelDamageFAR part
N4751S — — SUBS 091

Sequence of events

#OccurrencePhase
1 Initial climb Loss of engine power (partial) defining Takeoff
2 Landing-flare/touchdown Landing gear not configured Cruise
3 Landing-flare/touchdown Hard landing Cruise

Findings

Finding
Aircraft-Aircraft power plant-Engine fuel and control-Fuel control/carburetor-Incorrect service/maintenance cause
Aircraft-Aircraft handling/service-Maintenance/inspections-(general)-Incorrect service/maintenance cause
Environmental issues-Conditions/weather/phenomena-Temp/humidity/pressure-Conducive to carburetor icing-Effect on operation factor