N1420W accident

NTSB GAA15CA202 · 2015-07-25 · De Queen, AR

Docket — crew, injuries and powerplant

Summary

According to the pilot of the skid-equipped helicopter, he had loaded the helicopter with the liquid to be used during the agricultural aerial application flight. The pilot and operator both stated during interviews, that performance planning calculations were not performed prior to the flight, regarding adjustments pertaining to weight and balance, density altitude, out of ground effect capability or in ground effect capability. According to the operator, an FAA approved weight and balance form was not provided to the pilot until after the accident. The pilot stated that during the takeoff from the elevated platform, he increased collective, established a 2 inch hover, applied forward cyclic, and the helicopter, "about a foot or two from the platform, shook violently and started to descend."  The pilot recounted that he turned the nose of the helicopter approximately 45 degrees to the left and the main rotor blades impacted the tank truck upon which the elevated platform was mounted. When asked, the pilot stated that, "the temperature was hot, possibly in the lower 80 degrees Fahrenheit, and no wind." The nearest weather station was 7 miles east of the accident site and reported 100 percent humidity, a temperature of 73.4 degrees Fahrenheit, a dew point of 73.4 degrees Fahrenheit, no wind and a density altitude of 1,698.7 feet, at an airport elevation of 355 feet. The accident site elevation was 457 feet. The helicopter sustained substantial damage to the fuselage and main rotor system. The pilot reported that there were no mechanical malfunctions or failures with the helicopter prior to the flight that would have precluded normal operation.

Full narrative

According to the pilot of the skid-equipped helicopter, he had loaded the helicopter with the liquid to be used during the agricultural aerial application flight. The pilot and operator both stated during interviews, that performance planning calculations were not performed prior to the flight, regarding adjustments pertaining to weight and balance, density altitude, out of ground effect capability or in ground effect capability. According to the operator, an FAA approved weight and balance form was not provided to the pilot until after the accident.

The pilot stated that during the takeoff from the elevated platform, he increased collective, established a 2 inch hover, applied forward cyclic, and the helicopter, "about a foot or two from the platform, shook violently and started to descend." The pilot recounted that he turned the nose of the helicopter approximately 45 degrees to the left and the main rotor blades impacted the tank truck upon which the elevated platform was mounted.

When asked, the pilot stated that, "the temperature was hot, possibly in the lower 80 degrees Fahrenheit, and no wind." The nearest weather station was 7 miles east of the accident site and reported 100 percent humidity, a temperature of 73.4 degrees Fahrenheit, a dew point of 73.4 degrees Fahrenheit, no wind and a density altitude of 1,698.7 feet, at an airport elevation of 355 feet. The accident site elevation was 457 feet.

The helicopter sustained substantial damage to the fuselage and main rotor system.

The pilot reported that there were no mechanical malfunctions or failures with the helicopter prior to the flight that would have precluded normal operation.

Probable cause

The pilot's failure to conduct helicopter performance planning, which resulted in an uncontrolled descent and impact with a truck and terrain during takeoff from an elevated platform. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
4
Wind direction
0
Temperature (F)
73
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N1420W — — SUBS 137

Sequence of events

#OccurrencePhase
1 Takeoff Collision during takeoff/land defining Takeoff
2 Takeoff Collision with terr/obj (non-CFIT) Takeoff

Findings

Finding
Personnel issues-Task performance-Planning/preparation-Performance calculations-Pilot cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Climb rate-Not attained/maintained cause
Organizational issues-Support/oversight/monitoring-Oversight-Oversight of personnel-Operator factor
Environmental issues-Conditions/weather/phenomena-Temp/humidity/pressure-High density altitude-Effect on operation factor