N1785H Howard Aircraft DGA 15P accident
NTSB GAA15CA294 · 2015-09-25 · Englewood, CO · near APA
Docket — crew, injuries and powerplant
Summary
The pilot reported that he was en route to his destination and three to four miles before reaching the runway, he lost elevator authority. The pilot used elevator trim and power settings to control pitch and descended over the runway. The pilot was able to level off over the runway and tried to get the airspeed to decrease. The airplane descended, impacted the runway, and sustained substantial damage to a wing strut. A postaccident examination by the FAA revealed the elevator control separated at a connection between the control cable and a push/pull tube. The tube and cable ends remained intact, and showed no signs of deformation or fatigue. The bolt connecting them was missing and not recovered for examination. According to methods, techniques, and practices in Advisory Circular 43.13B the bolt should have been secured with a castellated nut and cotter pin, and neither were recovered from the wreckage.
Full narrative
The pilot reported that he was en route to his destination and three to four miles before reaching the runway, he lost elevator authority. The pilot used elevator trim and power settings to control pitch and descended over the runway. The pilot was able to level off over the runway and tried to get the airspeed to decrease. The airplane descended, impacted the runway, and sustained substantial damage to a wing strut.
A postaccident examination by the FAA revealed the elevator control separated at a connection between the control cable and a push/pull tube. The tube and cable ends remained intact, and showed no signs of deformation or fatigue. The bolt connecting them was missing and not recovered for examination. According to methods, techniques, and practices in Advisory Circular 43.13B, the bolt should have been secured with a castellated nut and cotter pin, and neither were recovered from the wreckage.
Probable cause
The separation of the elevator control system linkage at a push/pull tube and cable joint, for an unknown reason, because the bolt and associated hardware securing the joint was not found for examination. The National Transportation Safety Board determined the probable cause of this accident.
Circumstances
- Event type
- Accident
- Highest injury
- None
- Weather conditions
- Visual Meteorological Cond
- Light condition
- Day
- Ceiling (ft)
- 0
- Visibility (sm)
- 10
- Wind direction
- 60
- Wind speed (kt)
- 7
- Temperature (F)
- 82
- Nearest airport
- CENTENNIAL
- Distance from field
- 1.0
- Airport elevation
- 5885
Aircraft
| Registration | Make | Model | Damage | FAR part |
|---|---|---|---|---|
| N1785H | HOWARD AIRCRAFT | DGA 15P | SUBS | 091 |
Sequence of events
| # | Occurrence | Phase |
|---|---|---|
| 1 | Approach-VFR pattern final Flight control sys malf/fail defining | Cruise |
| 2 | Approach-VFR pattern final Loss of control in flight | Cruise |
| 3 | Landing-flare/touchdown Abnormal runway contact | Cruise |
| 4 | Landing-flare/touchdown Part(s) separation from AC | Cruise |
Findings
| Finding | |
|---|---|
| Aircraft-Aircraft systems-Flight control system-Elevator control system-Failure | cause |
| Aircraft-Aircraft systems-Flight control system-Elevator control system-Malfunction | factor |