N174CD Robinson Helicopter Company R44 II accident

NTSB GAA16CA006 · 2015-10-05 · Devine, TX

Docket — crew, injuries and powerplant

Summary

The pilot reported that during takeoff from a field next to an office building, the helicopter came in contact with one or two power lines, which caught on the left skid, and pulled the helicopter to the left. The main rotor blades contacted two power lines, and cut both of them. The pilot attempted to maintain control of the helicopter but it rolled to the left and impacted the ground. He reported that "the wires hit were invisible to me at the time of departure." A postflight inspection revealed substantial damage to the fuselage, the main rotor blade system, the tail boom, and the tail rotor blade system.  The pilot reported there were no pre-impact mechanical failures or malfunctions with the airframe or engine that would have precluded normal operation.

Full narrative

The pilot reported that during takeoff from a field next to an office building, the helicopter came in contact with one or two power lines, which caught on the left skid, and pulled the helicopter to the left. The main rotor blades contacted two power lines, and cut both of them. The pilot attempted to maintain control of the helicopter but it rolled to the left and impacted the ground. He reported that "the wires hit were invisible to me at the time of departure." A postflight inspection revealed substantial damage to the fuselage, the main rotor blade system, the tail boom, and the tail rotor blade system.

The pilot reported there were no pre-impact mechanical failures or malfunctions with the airframe or engine that would have precluded normal operation.

The pilot also stated as a safety recommendation, it would be "Best to walk the entire departure path, look for poles, wires, and guy wires prior to departure, especially with trees present, and a dark day which conceals the presence of wires. Don't get locked into one departure route. Turn the cellphone off when evaluating sites, and look 360 degrees."

ADDITIONAL INFORMATION

Robinson Helicopter Company Safety Notice SN-16

Robinson Helicopter Company has published Safety Notice SN-16 Power Lines Are Deadly (revised June 1994). This safety notice discusses wire strike mitigation techniques. The safety notices states;

Flying into wires, cables, and other objects is by far the number one cause of fatal accidents in helicopters. Pilots must constantly be on the alert for this very real hazard.

Watch for the towers; you will not see the wires in time. Fly directly over the towers when crossing power lines. Allow for the smaller, usually invisible, grounding wire(s) which are well above the larger more visible wires. Constantly scan the higher terrain on either side of your flight path for towers. Always maintain at least 500 feet above ground level (AGL) except during takeoff and landing. By always flying above 500 feet AGL, you can virtually eliminate the primary cause of fatal accidents.

Probable cause

The pilot's failure to maintain obstacle clearance during the takeoff, which resulted in the helicopter striking power lines. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Wind speed (kt)
5
Temperature (F)
86
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N174CD ROBINSON HELICOPTER COMPANY R44 II SUBS 091

Sequence of events

#OccurrencePhase
1 Takeoff Collision during takeoff/land defining Takeoff
2 Takeoff Attempted remediation/recovery Takeoff
3 Takeoff Loss of control in flight Takeoff
4 Takeoff Collision with terr/obj (non-CFIT) Takeoff

Findings

Finding
Personnel issues-Psychological-Attention/monitoring-Task monitoring/vigilance-Pilot cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Altitude-Not attained/maintained cause
Environmental issues-Physical environment-Object/animal/substance-Wire-Awareness of condition factor
Environmental issues-Physical environment-Object/animal/substance-Wire-Effect on operation factor