N5703L American AA 1 accident

NTSB GAA16CA149 · 2016-03-12 · Brigham City, UT · near BMC

Docket — crew, injuries and powerplant

Summary

The pilot reported that during the takeoff roll about 60 knots with a "slight" crosswind, he "felt an abrupt" turn to the right, heard a "huge steady scrape" sound, and noted a vibration. Airborne at 65 knots, he reported a strong gust of wind from the left which felt like a quartering tail wind. He reported that he did not believe he had touched back down on the runway after becoming airborne. The pilot then flew the airplane over the airport where a local pilot on the ground reported to him that the nose landing gear was bent. During the subsequent landing, he reported that he made a soft field type of landing with the main landing gear touching down first. He held the nose landing gear off the ground as long as possible but when the nose landing gear touched down, he had no directional control and he heard a scraping noise. The airplane departed the runway to the right into a ditch and nosed over. The airplane sustained substantial damage to the fuselage, left wing, and vertical stabilizer. The pilot reported that he took off on runway 17 about 1410. The weather observation facility at the accident airport reported that from 1355 to 1415, the wind velocity varied from 13 knots to 15 knots with occasional gusts to 19 knots, and the wind direction varied from 190 to 240 degrees. According to the Federal Aviation Administration (FAA) Type Certificate Data Sheet, the maximum demonstrated crosswind component for the airplane is 15 miles per hour (13.03 knots). The FAA has published the Airplane Flying Handbook FAA-H-8083-3A (2004). This handbook discusses operations in crosswind conditions and states in part: Takeoffs and landings in certain crosswind conditions are inadvisable or even dangerous. If the crosswind is great enough to warrant an extreme drift correction, a hazardous landing condition may result. Therefore, the takeoff and landing capabilities with respect to the reported surface wind conditions and the available landing directions must be considered. It is imperative that pilots determine the maximum crosswind component of each airplane they fly, and avoid operations in wind conditions that exceed the capability of the airplane.

Full narrative

The pilot reported that during the takeoff roll about 60 knots with a "slight" crosswind, he "felt an abrupt" turn to the right, heard a "huge steady scrape" sound, and noted a vibration. Airborne at 65 knots, he reported a strong gust of wind from the left which felt like a quartering tail wind. He reported that he did not believe he had touched back down on the runway after becoming airborne. The pilot then flew the airplane over the airport where a local pilot on the ground reported to him that the nose landing gear was bent.

During the subsequent landing, he reported that he made a soft field type of landing with the main landing gear touching down first. He held the nose landing gear off the ground as long as possible but when the nose landing gear touched down, he had no directional control and he heard a scraping noise. The airplane departed the runway to the right into a ditch and nosed over. The airplane sustained substantial damage to the fuselage, left wing, and vertical stabilizer.

The pilot reported that he took off on runway 17 about 1410. The weather observation facility at the accident airport reported that from 1355 to 1415, the wind velocity varied from 13 knots to 15 knots with occasional gusts to 19 knots, and the wind direction varied from 190 to 240 degrees.

According to the Federal Aviation Administration (FAA) Type Certificate Data Sheet, the maximum demonstrated crosswind component for the airplane is 15 miles per hour (13.03 knots).

The FAA has published the Airplane Flying Handbook FAA-H-8083-3A (2004). This handbook discusses operations in crosswind conditions and states in part:

Takeoffs and landings in certain crosswind conditions are inadvisable or even dangerous. If the crosswind is great enough to warrant an extreme drift correction, a hazardous landing condition may result. Therefore, the takeoff and landing capabilities with respect to the reported surface wind conditions and the available landing directions must be considered.

It is imperative that pilots determine the maximum crosswind component of each airplane they fly, and avoid operations in wind conditions that exceed the capability of the airplane.

Probable cause

Loss of directional control during landing, due to nose landing gear damage sustained in the prior takeoff, resulting in a runway excursion and nose over. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
OVC
Ceiling (ft)
9000
Visibility (sm)
10
Wind direction
230
Wind speed (kt)
12
Temperature (F)
59
Nearest airport
BRIGHAM CITY
Distance from field
0.0
Airport elevation
4229

Aircraft

RegistrationMakeModelDamageFAR part
N5703L AMERICAN AA 1 SUBS 091

Sequence of events

#OccurrencePhase
1 Takeoff Other weather encounter Takeoff
2 Takeoff Collision during takeoff/land defining Takeoff
3 Landing-landing roll Loss of control on ground Cruise
4 Landing-landing roll Runway excursion Cruise
5 Landing-landing roll Nose over/nose down Cruise
6 Landing-landing roll Collision during takeoff/land Cruise

Findings

Finding
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Directional control-Attain/maintain not possible cause
Aircraft-Aircraft systems-Landing gear system-Nose/tail landing gear-Damaged/degraded factor