N118ET accident

NTSB GAA16CA157 · 2016-03-20 · Nashville, TN · near JWN

Docket — crew, injuries and powerplant

Summary

The pilot reported that during landing in crosswind conditions, the airplane began to drift to the right over the runway lights in the landing flare. The pilot further reported that he determined "it was not safe to land" and applied full power to go-around and subsequently retracted the flaps from 30 degrees to zero degrees. During the go-around, he reported that the airplane was unable to gain airspeed or altitude and touched down in the grass next to the runway and aborted the go-around. Subsequently, the pilot taxied back onto the runway and proceeded to the ramp. A postaccident examination revealed substantial damage to elevator and rudder. The pilot reported that "he did not realize the angle of attack was severe enough" to cause a tail strike during the go-around. The Cessna 172R (180 HP) Pilot's Operating Handbook in part states: "In a balked landing (go-around) climb, reduce the flap setting to 20 degrees immediately after full power is applied. If obstacles must be cleared during the go-around climb, reduce the wing flap setting to 10 degrees and maintain a safe airspeed until the obstacles are cleared." The pilot reported that there were no mechanical malfunctions or failures with the airplane that would have precluded normal operation.

Full narrative

The pilot reported that during landing in crosswind conditions, the airplane began to drift to the right over the runway lights in the landing flare. The pilot further reported that he determined "it was not safe to land" and applied full power to go-around and subsequently retracted the flaps from 30 degrees to zero degrees. During the go-around, he reported that the airplane was unable to gain airspeed or altitude and touched down in the grass next to the runway and aborted the go-around. Subsequently, the pilot taxied back onto the runway and proceeded to the ramp.

A postaccident examination revealed substantial damage to elevator and rudder. The pilot reported that "he did not realize the angle of attack was severe enough" to cause a tail strike during the go-around.

The Cessna 172R (180 HP) Pilot's Operating Handbook in part states: "In a balked landing (go-around) climb, reduce the flap setting to 20 degrees immediately after full power is applied. If obstacles must be cleared during the go-around climb, reduce the wing flap setting to 10 degrees and maintain a safe airspeed until the obstacles are cleared."

The pilot reported that there were no mechanical malfunctions or failures with the airplane that would have precluded normal operation.

Probable cause

The pilot's excessive pitch up and incorrect action of selecting flaps to zero degrees, which resulted in a tail strike during a go-around in crosswind conditions. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
BKN
Ceiling (ft)
5000
Visibility (sm)
10
Wind direction
270
Wind speed (kt)
14
Temperature (F)
43
Nearest airport
JOHN C TUNE
Distance from field
0.0
Airport elevation
501

Aircraft

RegistrationMakeModelDamageFAR part
N118ET — — SUBS 091

Sequence of events

#OccurrencePhase
1 Landing-flare/touchdown Other weather encounter Cruise
2 Approach-VFR go-around Loss of lift Cruise
3 Approach-VFR go-around Tailstrike defining Cruise

Findings

Finding
Aircraft-Aircraft structures-Wing structure-Trailing edge flaps-Incorrect use/operation cause
Personnel issues-Action/decision-Action-Incorrect action selection-Pilot cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Pitch control-Capability exceeded cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Climb rate-Not attained/maintained factor
Environmental issues-Conditions/weather/phenomena-Wind-Crosswind-Ability to respond/compensate factor